HomeMy WebLinkAboutGorilla Manufacturing Generator StandsGorilla Manufacturing Generator Stands
Stands manufactured in the following heights:
12", 24", 36", 48", 60", 72" 84"
Sized to fit both Generac and Kohler (26" by 49") everything is fully MIG
welded. The fully welded, one piece construction, speeds the installation
and make the stands unbelievably sturdy.
A painted finish is standard. Paint can be deleted or upgraded to powder
coat or galvanized finish. Bare steel or painted stands are typically in
stock but that can vary according to demand. Powder coated or galvanized
finishes are available but add a delay.
Top support frames are 4" by 3" by 1/4" angle. Secondary stabilizing
frames on the 36" and taller models are 3" by 3" by 1/4" angle.
All models use 3" by 3" by 1/4" square tubular legs. Each leg mounting
pad is 4" by 6.5" by 1/4" with a pre -drilled hole for 1/2" hold down hardware.
Mounting holes for Generac and Kohler generators are pre -drilled
D m 0 m m
mGo
=rt-i3m'" r� so 107' M
0
I <o
I
N
Gorilla Manufacturing
19525 Wied Rd
Suite 102
Spring, TX 77388
281-705-9701
48" stand shown
GENERAL SPECIFICATIONS FOR
GORILLA MANUFACTURING
GENERATOR STANDS
REV A
12/31/2018