The URL can be used to link to this page

Home My WebLink AboutPRODUCT APPROVAL QUIKRETE - Mortar Tile NOA No.: 19-0226.08 Expiration Date: 11/06/24 Approval Date: 04/18/19 Page 1 of 6 MIAMI-DADE COUNTY PRODUCT CONTROL SECTION 11805 SW 26 Street, Room 208 DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) Miami, Florida 33175-2474 BOARD AND CODE ADMINISTRATION DIVISION T (786)315-2590 F (786) 315-2599 NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/economy The Quikrete Companies, LLC. 5 Concourse Parkway, Suite 1900 Atlanta, GA. 30328 SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The documentation submitted has been reviewed and accepted by Miami-Dade County RER -Product Control Section to be used in Miami Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ). This NOA shall not be valid after the expiration date stated below. The Miami-Dade County Product Control Section (In Miami Dade County) and/or the AHJ (in areas other than Miami Dade County) reserve the right to have this product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is determined by Miami-Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein, and has been designed to comply with the Florida Building Code including the High Velocity Hurricane Zone of the Florida Building Code. DESCRIPTION: QUIKRETE® Roof Tile Mortar FL-15 LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state and following statement: "Miami-Dade County Product Control Approved", unless otherwise noted herein. RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. ADVERTISEMENT: The NOA number preceded by the words Miami-Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. This NOA revises NOA 18-1129.04 and consists of pages 1 through 6. The submitted documentation was reviewed by Alex Tigera. NOA No.: 19-0226.08 Expiration Date: 11/06/24 Approval Date: 04/18/19 Page 2 of 6 ROOFING COMPONENT APPROVAL: Category: Roofing Sub Category: Roofing Tile Adhesives Materials: Cement SCOPE: This approves QUIKRETE® Roof Tile Mortar FL-15 as manufactured by The Quikrete Companies, LLC. as described in this Notice of Acceptance. PRODUCTS MANUFACTURED BY OR LABELED BY APPLICANT: Product Dimensions Test Specifications Product Description QUIKRETE® Roof Tile Mortar FL-15 80 lb. bags TAS 123 Premixed pre-bagged gray roof tile mortar for use with approved roof tiles in accordance with RAS 120 MANUFACTURING LOCATIONS: 1. Miami, FL 2. Lakeland, FL 3. Jacksonville, FL 4. Ft. Myers, FL. EVIDENCE SUBMITTED: Test Agency Test Identifier Test Name/Report Date Center for Applied Engineering Metro Dade Protocol TAS 101 Florida Testing and Engineering, Inc. ASTM C 91 Type M PRI Construction Materials Technologies TAS 123 QKT-003-02-01 10/15/09 TAS 123 QKT-004-02-02INT 10/23/14 TAS 123 QKT-007-02-01 06/26/15 Construction Technology Laboratories, Inc. ASTM C 270 385045 06/14/10 NOA No.: 19-0226.08 Expiration Date: 11/06/24 Approval Date: 04/18/19 Page 3 of 6 LIMITATIONS: 1. Fire classification is not part of this acceptance. Refer to the Prepared Roof Tile Assembly for fire rating. 2. Field uplift testing shall be performed, in accordance with the test procedures set forth in Roofing Application Standard TAS 106. Testing shall be performed not prior to 30 days after installation. 3. Quikrete® Roof Tile Mortar FL – 15 shall be placed in a 5" x 12" pad at time of application. The mortar pad placement shall be in accordance with the 'Placement Details' provided herein. Each generic tile profile requires a specific placement, (see Placement Detail listed herein). 4. Quikrete® Roof Tile Mortar FL - 15 shall be applied in accordance with The Quikrete Companies, LLC’s specifications. 5. Tile must be applied within 5 minutes of the application of Quikrete® Roof Tile Mortar. FL – 15. 6. Refer to the tile manufacturer’s Miami-Dade County Product Control Notice of Acceptance for system approvals. 7. All products listed herein shall have a quality assurance audit in accordance with the Florida Building Code and Rule 61G20-3 of the Florida Administrative Code. 5. All bags shall be labeled and shall bear the imprint or identifiable marking of the manufacturer's name or logo, city and state of manufacturing facility, and following statement: "Miami-Dade County Product Control Approved" or the Miami-Dade County Product Control Seal as shown below. INSTALLATION: 1. Quikrete® Roof Tile Mortar FL - 15 and its components shall be installed in strict compliance with Roofing Application Standard RAS 120. 2. Mortar placement shall be in accordance with the placement details specified below. PLACEMENT DETAILS TILE PROFILE: DETAIL NO. Medium Profile A Flat Profile B High Profile C BUILDING PERMIT REQUIREMENTS: 1. As required by the Building Official or applicable building code in order to properly evaluate the installation of this system. NOA No.: 19-0226.08 Expiration Date: 11/06/24 Approval Date: 04/18/19 Page 4 of 6 PLACEMENT DETAIL "A" PLACEMENT DETAIL "B" NOA No.: 19-0226.08 Expiration Date: 11/06/24 Approval Date: 04/18/19 Page 5 of 6 PLACEMENT DETAIL "C" NOA No.: 19-0226.08 Expiration Date: 11/06/24 Approval Date: 04/18/19 Page 6 of 6 PLACEMENT DETAIL "C" (CONTINUED) END OF THIS ACCEPTANCE