Loading...
HomeMy WebLinkAbout20092232 - NOA 10' GR2LP W6 NOA-No. 20-0922.32 Expiration Date: July 18, 2023 Approval Date: November 25, 2020 Page 1 MIAMI -DADE COUNTY PRODUCT CONTROL SECTION 11805 SW 26 Street, Room 208 DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) Miami, Florida 33175-2474 BOARD AND CODE ADMINISTRATION DIVISION T (786) 315-2590 F (786) 315-2599 NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/economy Clopay Corporation 8585 Duke Boulevard Mason, OH 45040 S COPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The documentation submitted has been reviewed and accepted by Miami-Dade County RER-Product Control Section to be used in Miami-Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ). This NOA shall not be valid after the expiration date stated below. The Miami-Dade County Product Control Section (In Miami-Dade County) and/ or the AHJ (in areas other than Miami-Dade County) reserve the right to have this product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is determined by Miami- Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein and has been designed to comply with the Florida Building Code, including the High Velocity Hurricane Zone. DESCRIPTION : 2 in Gallery EPS Insulated W6 DP38T Steel Sectional Garage Door up to 16 ft-2 in Wide w/ Optional Impact Resistant Lites APPROVAL DOCUMENT: Drawing No. 104785, titled “2” Gallery EPS Doors 16’2”W”, sheets 1 through 3 of 3, dated 01/10/2013, with revision 06 dated 08/28/2020, prepared by Clopay Co rporation, dated 09/10/2020, signed and sealed by Scott Hamilton, P.E., bearing the Miami-Dade County Product Control revision stamp with the Notice of Acceptance number and expiration date by the Miami-Dade County Product Control Section. MISSILE IMPACT RATING: Large and Small Missile Impact Resistant LABELING: A permanent label with the manufacturer’s name or logo, manufacturing address, model number, the positive and negative design pressure rating, indicate impact rated if applicable, installation instruction drawing reference number, approval number (NOA), the applicable test standards, and the statement reading ‘Miami-Dade County Product Control Approved’ is to be located on the door’s side track, bottom angle, or inner surface of a panel. R ENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials, use, and/ or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. A DVERTISEMENT: The NOA number preceded by the words Miami-Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. This NOA revises NOA # 18-0510.02 and consists of this page 1 and evidence page s E-1 , E-2, E-3 and E -4 , as well as approval document mentioned above. The submitted documentation was reviewed by Carlos M. Utrera, P.E. Carlos M. Utrera, P.E. Product Control Examiner NOA-No. 20-0922.32 Expiration Date: July 18, 2023 Approval Date: November 25, 2020 E - 1 Clopay Corporation NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 1. EVIDENCE SUBMITTED UNDER PREVIOUS NOA’S A. DRAWINGS “Submitted under NOA # 14-0203.06” 1. Drawing No. 104785, titled “2” Gallery EPS Doors 16’2”W”, sheet s 1 through 3 of 3, dated 01/10/2013, with revision 04 dated 09/20/2016 , prepared by Clopay Building Products Company, signed and sealed by Scott Hamilton, P.E. B. TESTS “Submitted under NOA # 14-0203.06” 1. Test reports on 1) Uniform Static Air Pressure Test, Loading per FBC TAS 202 -94 2) Large Missile Impact Test per FBC, TAS 201-94 3) Cyclic Wind Pressure Loading per FBC, TAS 203-94 4) Forced Entry Test per FBC, TAS 202-94 5) Tensile Test per ASTM E8 Along with marked-up drawings a nd installation diagram of 16’2”x 8’, 27ga steel garage door Model GD2LPW8 with windows, prepared by American Test Lab, Inc., Test Report No. ATLNC 1202.02-13, dated 01/14/2014, signed and sealed by David W. Johnson, P.E. “Submitted under NOA # 13-0423.15” 2. Test reports on 1) Uniform Static Air Pressure Test, Loading per FBC TAS 202 -94 2) Large Missile Impact Test per FBC, TAS 201-94 3) Cyclic Wind Pressure Loading per FBC, TAS 203-94 4) Forced Entry Test, per FBC, TAS 202-94 5) Tensile Test per ASTM E8 Along with marked-up drawings and installation diagram of 16’2”x 8’, 27ga steel garage door Model GD2LPW6 with windows, prepared by American Test Lab, Inc., Test Report No. ATLNC 0115-01-13R, dated 03/18/2013 , signed and sealed by David W. Johnson, P.E. 3. Test report on Salt Spray per ASTM B117 of painted G40 galvanized coated panels, prepared by Stork Materials Technology, Test Report No. 30160 -04-63365, dated 01/26/2005, signed by John D. Lee, P.E. C. CALCULATIONS “Submitted under NOA # 13 -0423.15” 1. Jamb anchor calculations prepared by Clopay Building Products Company, dated 04/16/2013, signed and sealed by Scott Hamilton, P.E. D. QUALITY ASSURANCE 1. Miami-Dade Department of Re gulatory and Economic Resources (RER). E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 13-0717.01 issued to SABIC Innovative Plastics for their Lexan Polycarbonate Sheet Products, approved on 11/28/2013, expiring on 07/17/2018. 2. Test report on Surface Burning Characteristics, per ASTM E84 of Type I EPS, Test Report No. 3082960-500 , prepared by Intertek Testing Services, NA, Inc., dated 10/04/2005, signed by Javier Trevino. Carlos M. Utrera, P.E. Product Control Examiner NOA-No. 20-0922.32 Expiration Date: July 18, 2023 Approval Date: November 25, 2020 E - 2 Clopay Corporation NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED E. MATERIAL CERTIFICATIONS (Continued) 3. Test report on Ignition Properties of Plastics per ASTM D1929 of Type I EPS, Test Report No. 3082959-500, prepared by Intertek Testing Services, NA, Inc., dated 09/16/2005, signed by C. Anthony Peñaloza. F. STATEMENTS “Submitted under NOA # 15-0225.21” 1. Statement letter of code conformance with the 2010 and the 5th edition (2014) FBC issued by Clopay Building Products Company, dated 02/18/2015, signed and sealed by Scott Hamilton, P.E. “Submitted under NOA # 13-0423.15” 2. Statement letters of code conformance to 2010 FBC and no financial interest, both issued by Clopay Building Products Company, dated 04/16/2013, signed and sealed by Scott Hamilton, P.E. 2. EVIDENCE SUBMITTED UNDER PREVIOUS NOA’S A. DRAWINGS “Submitted under NOA # 17-1016.26” 1. Drawing No. 104785, titled “2” Gallery EPS Doors 16’2”W”, sheets 1 through 3 of 3, dated 01/10/2013, with revision 05 dated 07/18/2017, prepared by Clopay Building Products Company, signed and sealed by Scott Hamilton, P.E. B. TESTS 1. None. C. CALCULATIONS 1. None. D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER). E. MATERIAL CERTIFICATIONS 1. None. F. STATEMENTS “Submitted under NOA # 17-1016.26” 1. Statement letter of code conformance to the 6th edition (2017) FBC issued by Clopay Building Products Company, dated 10/04/2017, signed and sealed by Scott Hamilton, P.E. Carlos M. Utrera, P.E. Product Control Examiner NOA-No. 20-0922.32 Expiration Date: July 18, 2023 Approval Date: November 25, 2020 E - 3 Clopay Corporation NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 3. EVIDENCE SUBMITTED UNDER PREVIOUS NOA # 18-0510.02 A. DRAWINGS 1. Drawing No. 104785, titled “2” Gallery EPS Doors 16’2”W”, sheets 1 through 3 of 3, dated 01/10/2013, with revision 05 dated 07/18/2017, prepared by Clopay Building Products Company, dated 04/27/2018, signed and sealed by Scott Hamilton, P.E. B. TESTS 1. None. C. CALCULATIONS 1. None. D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER). E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 15-0915.08 issued to Sabic Innovative Plastic, US, LLC for their “LEXAN® Polycarbonate Sheet Products” dated 12/10/1 5, expiring on 07/17/18. F. STATEMENTS 1. Statement letter of code conformance to the 6th edition (2017) FBC issued by Clopay Building Products Company, dated 04/27/2018, signed and sealed by Scott Hamilton, P.E. 2. Statement letter of no financial interests issued by Clopay Building Products Company, dated 04/27/2018, signed and sealed by Scott Hamilton, P.E. Carlos M. Utrera, P.E. Product Control Examiner NOA-No. 20-0922.32 Expiration Date: July 18, 2023 Approval Date: November 25, 2020 E - 4 Clopay Corporation NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 4. NEW EVIDENCE SUBMITTED A. DRAWINGS 1. Drawing No. 104785, titled “2” Gallery EPS Doors 16’2”W”, sheets 1 through 3 of 3, dated 01/10/2013, with revision 06 dated 08/28/2020, prepared by Clopay Corporation, dated 09/10/2020, signed and sealed by Scott Hamilton, P.E. B. TESTS 1. None. C. CALCULATIONS 1. None. D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER). E. MATERIAL CERTIFICATIONS 1. None. F. STATEMENTS 1. Statement letters of code conformance to 6th Edition (2017) and 7th Edition (2020) FBC, issued by Clopay Corporation, dated 09/15/2020, signed and sealed by Scott Hamilton, P.E. 2. Certificate of amendment changing the company name from Clopay Building Products Company, Inc. to Clopay Corporation, issued by the State of Delaware, dated 08/27/2019.