HomeMy WebLinkAboutLow Pressure Sewer System ApplicationCITY OF PORT ST. LUCIE UTILITY SYSTEMS DEPARTMENT
LOW PRESSURE SEWER SYSTEM APPLICATION
ACCT# 831594 CUST# 0847327 FILE # LOT 52 BLOCK 32 UNT 4
STREET ADDRESS 465 SE VERADA AVENUE X-STREET
BUILDER'S NAME GPANDF C0NSTR11CTTnN PHnNF
- CONDITIONS -
Applicant understands the following instructions and responsibility before the low-pressure system
installation. All scheduled installations are subject to change due to weather and other Utility
emergencies. For additional questions and/or clarification, please email us at
utilitysewer@cityofpsi.com.
1. Accepts instructions regarding the electrical requirements through explanation and receipt of
electrical schematic. Must provide (1) 20-amp (minimum) breaker for use to supply power to the
pump and (1) 15-amp (minimum) breaker for use to supply power for the control circuit. Pump
power minimum wire size 12 gauge copper conductor (75-C). Control circuit minimum wire size 12
gauge copper conductor (75-C). The wire size is based on less than 100Ft. Acknowledges distance
between electrical control box and interceptor tank will not exceed twenty-five (25) feet. NOTE:
As of April 1993 installation requires two (2) separate breakers on same phase in panel
box.
2. Instructed as to location of pressure main (stub -out must be on side of house facing main): i.e.
Front Back
3. If sewer stub -out is on the same side as water meter, a 3" PVC sleeve 20' back from garage door
is required 18" under driveway to install the Utility's 11/2" service line if the pressure main is in
front of the house.
4. Lot must be clear of all construction debris, lot rough graded and house stucco completed. Final
grade and sod cannot be done until tank set is completed.
5. Accepts responsibility to email City of Port St. Lucie Utility Systems Department- at
utilitysewer@cityofpsl.com when the pre -inspection items are ready. If inspection fails, there will
be a $25.00 fee for re -inspect. Contractor is required to call back for 2"d Pre -Inspection when the
deficiency has been resolved.
6. Acknowledges the responsibility to correct all deficiencies at applicant's expense and eliminate
any conflicts in the way of Utility tank lines.
7. Acknowledges responsibility for inspection fee of $25.00 for each follow-up pre -inspection visit
required to satisfy non-compliance items.
Builder/Owner / f Otis• Date
Utility Systems Department Representative MARIA B Date 01/14/21
1/14/2021