HomeMy WebLinkAboutREVISION, Futuro-Futuro-Savona-Range-Hood-Installation-ManualFuturo FuturoFuturo Futuro
RANGE HOOD
INSTALLATION MANUAL
MODEL: SAVONA CEILING
NOTE: PRIOR TO INSTALLATION
Please inspect range hood visually,
as well as connect it to power supply
and test its operation.
35 1/2”24”18”2 1/4”2 1/4”6 7/8”25 1/2”4 1/4”
4 7/8”
8 7
/
8
”
d
i
a
m
.6” diam.4 1/4”
34
5
/
8
”22 5/8”
34”
35 1/2”10 7/8”10 5/8”8 1/4”3/16”2 3/8”10 1/2”10 1/2”13”
34 5/8”22 5/8”25 1/2”18”
NOTE: Inch dimensions are approximate, and
given for reference / convenience only.
Always measure the actual items on-site and
make drilling / cutting marks according to
actual materials & measurements - not estimates.
GENERAL DIMENSIONS1
34”
4 5/8”4 5/8”
24”3/16”13”
1.) The outer panel is held in place by magnets.
To open the panel, pull down on the edge of the panel,
in BOTH of the indicated spots - in order to avoid
potentially warping the panel.
1.) Remove mounting bolts from hood.
2.) Place retaining frame against ceiling,
mark locations of screw holes, and drill holes.
NOTE: for concrete or masonry ceilings,
use plastic anchors as necessary.
3.) Secure retaining frame
to ceiling with mounting bolts.
PREPARATION
INSTALL RETAINING FRAME
2 2.) Remove filter panels
(2 on 36” version, 4 on 48” version)
& remove screws as shown.
3.) Disconnect blower cable.
4.) Close cover panels.
5.) Separate the retaining frame
(upper portion) from the
hood body (lower portion).
3
OPTION A: SIDE EXHAUST
OPTION B: TOP EXHAUST
2 3/4”
max. depth
1 3/16”
3/4”
6” diam.
6” diam.
Blower can be
installed with
duct exhaust
facing any direction
in 90-degree
increments
Main ceiling / joists
Mounting Bolt
(1 of 4, supplied
with hood)
Drop ceiling / sheetrock
This range hood features a blower enclosure that can be rotated in 90-degree increments,
in order to exhaust in different directions. If the factory default exhaust direction doesn’t
fit your installation needs - see sidebar on right for instructions on changing exhaust direction.
Otherwise, proceed to Step 5.
Using the provided screws,
secure the hood body (lower portion)
to the retaining frame (upper portion).
To change the direction of the
exhaust:
Remove the blower (4 screws).
Remove and re-orient the
enclosure.
Remove and re-orient duct collar
& block plate (opposite side).
Re-install the blower.
Re-install the enclosure.
CHOOSE BLOWER EXHAUST DIRECTION
ATTACH HOOD BODY
VARIABLE BLOWER DIRECTION4
5
Replace the filter panels,
and close the magnetic
cover plates.
REPLACE FILTERS6