HomeMy WebLinkAboutApproved Tyvek 160 product approvalMIANI-DADE COUNTY
PR0I)UCT COT`ITROL SECTION
I 1805 SW 26 Street, Room 208
Miami, Florida 33175-2474
T (786} 315-2590 F (786) 315-2599
!±|±!:\t',in_i±±Eid|±±E!±igov/e€L9P±±±±±±i
MiAMI.tueE\
couur
I)EPARTMENT oF REGtrLATORV AT`m EcoNOMTc REsouRCEs (RER)
BOARD AND CODE ADMINISTRATION DIVISION
NOTlcE OF AccEPTANCE aroA] __
Dupont De Nemours, Inc.
974 Centre Road, Chestnut Run Plaza 721-2246
Wilmington, DH 19805
ScOpE:
This NOA is being issued under the applicable rules and regulations govel.hung the use of construction materials. The
documentation submitted has been I.eviewed and accepted by Miami-Dade County RER - Product Control Section to be
used in Miami-Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ).
This NOA shall not be valid after the expiration date stated below. The Miami-Dade County Product Control Section
(in Miami~Dade County) and/or the AHJ (in areas other than Miami-Dade County) reserve the right to have this product
or material tested for quality assul.ance purposes. If this product or material fails to perform in the accepted manner, the
manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, ol. suspend the use
of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is
determined by Miami-Dade County Product Control Section that this product or material fails to meet the requirements
of the applicable building code.
This product is approved as described herein, and has been designed to comply with the Florida Building Code
including the High Velocity Hurricane Zone of the Florida Building Code.
DESCRIPTION:Dupont"Tyvek®PI.oTec"120,DuP-ont"Tyvik~®-Pi=oTec"1-60',lDupont"Tyvek®ProTec"200.
LABELING : Each unit shall bear a permanent label with the manufacturer's name or logo, city, state and following
statement: "Miami-Dade County Product Control Approved", unless otherwise noted herein.
RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change
in the applicable building code negatively affecting the performance of this product.
THRMINATI0N ot` this NOA will occur after the expiration date or if there has been a revision or change in the
materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for.
sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of
this NOA shall be cause for termination and removal of.NOA.
ADVERTISEMENT: The NOA number pi.eceded by the words Miami-Dade County, Florida, and followed by the
expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall be done
in its entirety.
INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer oi. its distributoi.s and
shall be available for inspection at the job site at the request of the Building Official.
This NOA revises NOA 19-0109.07 consists of pages I through 4.
The submitted documentation was reviewed by Frcddj; Semz.#o
MtAMLBADEcour`iTir
'="ili['l,J]']
NOA No.: 19J}828.02
Expil.ation Date: 01/23/25
Approval I)ate: 01/23/20
mge 1 t,t` 4
ROOFING C OMPONHNT APPROVAL
Category : Roofing
Sub-Categorv: Underlayment
M ateri al : Po lypropylene
ScOpE:
This approves Dupont" Tyvek® ProTec" 120, I)upont" Tyvek® ProTec" 160, Dupont" Tyvek® PI.oTec" 200 a§
described in this Notice of Acceptance; designed to comply with the Florida Building Code including the High Velocity
Huricane Zone of the Florida Building Code.
TRADE NAMES 0F PR0I)UCTS MANUFACTUREI) OR LABELED BY APPLICANT:
Product
Dupont"Tyvek®
PI.oTec" 120
Dupont"Tyvek®qu-`;RE
ProTec" 160
Dupont"Tyvek®
ProTec" 200
Dimensions
48" x 250' rolls
26 1bs. per roll
48" x 250` rolls
32 1bs. per roll
48" x 250' rolls
35 1bs. per roll
MANUFACTURING LOCATION:
1. QiTidao,China
EVIDENCE SUBMITTED :
Test Agencv
Intertek Testing Services
Nemo/etc.
MIAMI.BADE COUNTY'!"]i,.I,`]']
Test
Snecification
AS" D226 Type
1&11
ASTM D226 Type
I&11
ASTM D226 Type
I&11
Test Identifier
ioi866oogcoQroo2A
ioi866oogcoQrlo1
4j-DPBs-I 9-ssudlro I . A
Product
Descriution
Woven synthetic polymer underlayment with two
sides coated with UV protected and slip resistant
polymer stabi.lized polypropylene on both sl`des.
Woven synthetic polymer underlayment with two
sides coatedwith uv protected and slip resistant r
polymer stabilized polyptopylene oll both sides.
Woven synthetic polymer underlayment with two
sides coatedrwith UV protected and slip resistant
polymer stabilized polypropylene on both sides.
Test NamemeDort
Physical Properties
AS" D 226
AS" D 226
Date
11/19/14
11/17/14
09/ I 6/ I 9
NOA No.: 19-0828.02
Explmtlon Date: 01/23/25
Approval I)ate: 01/23/20
Page 2 ol' 4
INSTALLATION SPHCIFICATIONS : (Single Laver: Slopes of 2:12 or greater)
I)upont" Tyvek® ProTec" 120, Dupout" Tyvek® ProTec" 160, I)upont" Tyvek® ProTec" 200 Roof Underlayment
1. Dupont" Tyvek® PTOTec" 120, Dupont" Tyvek® ProTec" 160, Dupont" Tyvek® ProTecT^' 200 Roof
Underlayments shall be installed in strict compliance with applicable Building Code.
2.
3.
4.
5.
Dupont" Tyvek® ProTec" 120, Dupont" Tyvek®. ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof
Underlayments shall be installed with a minimum 4-inch horizontal lap and 6-inch vertical laps in a shingle
layer fashion. Vertical laps in a succeeding course shall be stagger.ed from those in preceding course by
minimum 6-feet.
Dupont" Tyvek® ProTec" 120, Dupont" Tyvek® ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof
Underlayments shall be fasteiied with approved roofing nails and tin-caps spaced 6" o.c. at all laps and three
staggered I.ows fastened 12" o.c. in the field of the I.oll.
Duponr` Tyvek® ProTec" 120, fupont" Tyvek® ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof
Underlayments may be used with Asphaltic shingles, Wood shakes and shingles, Non-structural metal roofing,
and quarry slate.
For fire classification of specific roof assemblies using DupontT`' Tyvek® ProTec" 120, Dupont" Tyvek'8'
ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof Underlayments refer to a current Approved Roofing
Materials Directory for fire ratings of this product.
BUILDING PERMIT REQUIREMENTS :
Application for building permit shall be accompanied by copies of the following:
1. This Notice of. Acceptance.
2. Any other documents required by the Building official or applicable building code ill order to properly evaluate
the installation of this material.
LIMITATIONS:
1. Fire classification is not part of this acceptance; refer to a current Approved Roofing Materials Directory for
fire ratings of this product.
2. This acceptance is for prepared roofing applications. Minimum deck requirements shall be in compliance with
applicable building code.
3. Dupont" Tyvek® ProTec" 120, Dupont" Tyvek® ProTec" 160, DupontT`' Tyvek® ProTec" 200 Roof
Underlayments shall be applied to a smooth, clean and dry surface with deck free of irregularities. All nails in
the deck shall be carefully checked for protruding heads. Re-fasten any loose decking panels. Sweep the deck
thoroughly to remove any dust and debris prior to application.
4. Dupont" Tyvek® ProTec" 120, Dupont" Tyvek® ProTec" 160, Dupontr-" Tyvek® ProTec" 200 Roof
UnderlaymeTits shall not be hot mopped, refdr to manufacturer's published literature for product compatibility.
5. Dupont" Tyvek® ProTec" 120, Dupont" Tyvek® ProTec" 160, DupontT." Tyvek® ProTec" 200 Root`
Underlayments shall not be applied over an existing roof membrane as a recover system.
6. DupontT`' Tyvek® ProTec" 120, Dupont" Tyvck® ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof`
Underlayments shall not be left exposed as a temporary roof for longer than 30 days of application.
MLAMLDADE coui`rTT
'!,ill:Ill,,]']
NOA No.: igro828.02
Expimtion Date: 01/23/25
Approval I)ate: 01/23/20
Page 3 of 4
7.Dupont" Tyvek® ProTec" 120, Dupont" Tyvek® ProTec" 160, DupontT`' Tyvek® ProTec" 200 Roof
Underlayments are components used in roof system assemblies. Roof system assemblies are approved under a
specific Notice of Acceptance. Refer to Prepared Roofing system Product Control Notice of Acceptance for
listed approval of this product with specific prepared roofing products.
8. DupontT^' Tyvek® ProTec" 120, Dut'ont" Tyvek® ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof
Underlayments may be used with any approved roof covering Notice of Acceptance listing Dupont" Tyvek®
ProTec" 120, Dupont" Tyvek® ProTec" 160, Ifupont" Tyvek®' ProTec" 200 Roof Underlayments as a
component part of an assembly in the Notice of Acceptance. If Dupont" Tyvek® ProTec" 120, Dupont"
Tyvek® ProTec" 160, Dupont" Tyvek® ProTec" 200 Roof underlayments ai.e not listed, a request may be
made to the Authority Having Jurisdiction (AHJ) or the Miami-Dade County Product Conti.ol Department for
approval provided that appropriate documentation is pi.ovided to detail compatibility of the products, wind
uplift resistance, and fire testing results.
9. All products listed hereiTi shall tiave a quality assuraTice audit in accordance with the Florida l3uilding code and
Rule 61 G20-3 of`the Florida Administrative Code.
1 0. All membranes or packaging shall bear the imprint or identifiable marking of the manufacturer's mme or logo,
city, state and the following statement: "Miami-Dade County Product Control Approved" or the Miami-Dade
County Product Control Seal as shown below.
'y\`ta _ ___ _
DuP®nt-Tyvekh Protec-120
rooilrlG u«O€¢l^VM{&T ,I :}eub.cutiti.7c pQ.jT `o!t .i baEL. pad tt!{hog
co' -]0.. MO .qrnipes| ,... I -- 7 ...- W2.® -r 1.3 -I 7..I in f®].9 in.I
DUE.ont+. Tyvek. Protec..160
ROol"G ll`Oii!il^Yut!jw /' {ouL {`-i`;fhi: p`.j'ji t®:,I .I hasp rld.`.a ler !iljs
•." I 21®' (. a .pl-.I / . i in * 7a2 -|®2® -. / . I -. 7e[2 rty fl2.. a.tl
MIAM I.EIADE COUNTY
rmlT'lmJT,I
Dif pant- Tyvek. ffrotec~ 200
eecfthLf u«D[RIA"tr.i / 2eur.`tc[fin pth.r t.iil ,i` tia6e givaf3 tat rit:,i
I." . aco' {f a .a..r`.,+| .f tB - I 7e.a - I.2 ..-. i . .2 .I. -7eL2 .. o3--]i
END 0F THIS ACCHPTANCH
NOA No.: 19-0828.02
Expiration I)ate: 01/23/25
Approval Date: 01/23/20
Page 4 Of 4