HomeMy WebLinkAboutProducts Review; Flame Safe Thatch SafeFlame Safe
FL ME FIRE RETARDANT Coatings Flame Retardant
Coatings
e
Hotline: 800-333-9197 8am-5pm (CST) Ph: 817-740-9197
2653 Warfield Street Fort Worth, After Hours: 817-658-9197 email: fireprod@aol.com
TX 76106
Dallas, Fort Wortb, Houston, Austin,Sauth Dallas, North Dallas, Dallas County, Houston, Corpus Chdsti, Sea Artonio, DFW roetroplm Dallas -Fort Wortb, Abilene, Amonllo, Odessa, Mldlaod, Hl Paso
INTERIOR/EXTERIOR FIRE RETARDANT
COATING or SPRAY FOR ROOF THATCHING, BAMBOO, REED,
KOA, TIKI HUT THATCHING
FF<�:
THE
CH
I § /"\ Fr ff='-I
PRODUCT DESCRIOPTION: Aqueous Based Resin
NFPA 701
TECHNICAL DATA
INTERIOR / EXTERIOR
PRODUCT ANALYSIS
Total Solids 42% PH 2.8 - 2.9
Weight per gallon F 11.9 Ibs Flash point Non -Flammable
Water clear at 78°F. -
Specific gravity 1.43 Color Slight haze at 50°F. or
lower
[_7Water(Contains no
[V,latability Non -Volatile Solvents petroleum or
derivatives of
petroleum)
II Thatching with cypress and koa II
CAUTION:
Product must not freeze. It must not be; thinned or diluted.
®VERSPRAYa
I
The overspray will not harm plants or animals. Spills can be flushed with water. A rag wetted with bleach and
water mix will clean up spotting.
Airless Equipment.
1. Run clear water through the system until coating is flushed out. When minor sudsing on surface stops, the
system is flushed.
2. Run bleach and water mix (1 part to 4 parts) through system as solvent for cleaning any residue.
3. Repeat Step 1 if any foaming occurs in Step 2.
4. Lubricate system as specified by equipment manufacturer to combat rusting.
If two or more applications are planned in the same day, the sprayer can be kept clean by running water
through the system between applications.
Brushes/Rollers.
i
1. Clean immediately after use.
2. Wash thoroughly with bleach and water mix (1 part to 4 parts).
SAFETY FIRST
Use approved safety devices (ropes, belts, ridge hooks, ladder, etc.) When working on steep or high areas. Take
EXTREME CARE not to step on Wet treated area. Surface may be slick until dry.
It i g^Cd practice to wear respirater or mask and protect hands with rubber gloves when spraying any coating
air cheinical.::: e : engineered, air control is not feasible, use properly maintained and properly fitted NIOSH
approved respirator for solvent vapors. A dusk mask sloes not provide protection against vapors.
Er^^A with wrater *.er ....een (151 r —ruteS and ::.AEI a r^Jsi-cla .. KEEP OUT OF
(Anti -Fungus II
excellent Resistance
Linear shrinkage
None
Corrosive
Mildly
Insects, rodents,
aspergilli And other types
of molds
Excellent resistance
Preservative for wood
Good
RECOGtfiME�i' DED USE, Interior/Exterior
Bacterial Good Resistance
Moisture Absorption None
Toxic None (when dry)
Termites II Excellent resistance
IFLARRE SAFE THATCH SAFE is a fire retardant coating. It can be used on any type of wood, porous, or non-
porous materials, such as:
Thatching Bamboo Koa Cypress
EMli8GMMENTAL REGULAT9GNe
This product complies will U. S. Federal Regulations concerning the use of lead in paint and hydrocarbon
emissions.
6t ATEE180AL 1 APPLOC ATOGM ICOVERAGE
Thatch, Bamboo, Koa, Treat before, during or after construction. Apply at rate of 200 sq. ft. per
Cyoress, Roof gallon
Thatching, TIM Hut Be sure surface is clean and dry before
Thatching treating.
Apply with 80 psi or greater sprayer at 8 to
12 inches from surface. Start at the top,
hold sprayer at up angle to roof pitch to
allow spry under thatching ends.
Apply with brush or roller.
May be necessary to wipe on hardwood
surfaces
Treat all surface areas where possible
Do not expose treated area to moisture for
24;hours.
EKrERIOR / OMTEROOR
All surfaces to be treated must be clean and dry.
Thatch Safe is water -based, clear liquid that becomes
insoluble when dry. Thatch Safe acts as a preservative,
and water proofing agent ultra violet inhibibor, mold and
mildew protector and repels insects. If over coating is
intended, Thatch Safe is an excellent surface primer for
use under latex paints or can be use as a finished coat
overwater based stains.
DO NOT DILUTE OR MIX hRE POLY 100 WITH ANY
OTHER PRODUCTS.
It should be noted that unlike some products,
materials treated with Thatch Safe require no special
cutting tools or special fasteners. Contact parts of any
equipment should be stainless steel or plastic to prevent
chemical reaction and breakdown. Storage may be done
in polyethylene containers.