HomeMy WebLinkAboutAPPROVED SBS-1-2-A Data SheetInsulated substrates: base sheet
and an SBS modified cap sheet
RI IRCTRATP
• Steel (Sec. 3.5)
• -.
• Wood (Sec. 3.10-3.11)
• Poured Gypsum (Sec. 3.12)
• Insulation (Sec. 4.0)
• Re-cover (Sec. 5.0)
MAXIMUM SLOPE:
Up to 6" :12" (Sec. 15.3)
ROOF ASSEMBLY:
One or more avers
and/orcoverboard:
• Base layer mechanically attached and
additional layers mechanically attached
or adhered in hot asphalt or approved
adhesive.
APPROVED BASE SHEETS
(one of the following)
• All Weather/Empire° Base Sheet
• Black Diamond° Base Sheet
colf_a hPrarll
• Flintlastic Base 20
• Flintlastic Ultra Glass SA (self -adhered)
• Flintlastic Ultra Poly SMS
• Glasbase'" Base Sheet
• Yosemite® Venting Base Sheet
APPROVED CAP SHEETS:
(one of the following)
• Flintlastir. FR (:an . n*
• Flintlastic FR-P*
• Flintlastic Premium FR-P*
FLASHING ASSEMBLY:
• Standard. Over a base sheet or bonded
to a primed substrate. One ply Flintlastic
modified cap sheet, per CT detail.
• Premium. Over a base sheet or bonded
to a primed substrate. One smooth and
one granulated modified membrane
flashing, per CT detail.
Premium Alternate. Over a base sheet
or bonded to a primed substrate. One
smooth modified membrane and CT
SmartFlash°, per CT detail.
Asphalt: Type III or Type IV (Sec. 7.0).
Cants: In angles of roof deck and vertical
surfaces, the roofing contractor shall furnish
and install an approved cant strip with a
minimum 3" face.
in hot asphalt or approved adhesive. FINAL SURFACING: *Available with CoolStat'reflective granules
• Vapor retarder/anchor sheets (Sec. 4.7). For optional surfacing see Section 14.0.
Approved base sheet, set in hot asphalt
(Sec. 7.0) or self -adhered (Sec. 10.2).
Approved cap sheet, mopped in hot asphalt
(Sec. 7.0).
SUMMARY OF MATERIALS:
• One or more layers of insulation
and/ or coverboard
• Base sheet (1 ply)
• Cap sheet (1 ply)
• ASTM D 312 asphalt (two moppings)
(One mopping if base sheet is self -
adhered)
CertainTeed
SAINT-GOBAIN
WARRANTY DURATIONS FOR THIS SPECIFICATION VARY BASED ON ROLL
MATERIAL SELECTION; SEE WARRANTY MATRIX.
Consult CertainTeed General Recommendations for noted section references.