The URL can be used to link to this page

Home My WebLink AboutAPPROVED SGD 400 20111806 A M IAM I•DADE MIAMI-DADE COUNTY PRODUCT CONTROL SECTION DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES(RER) 11805 SW 26 Street,Room 208 BOARD AND CODE ADMINISTRATION DIVISION T(786)315-2590 F(786)315-2599 NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/economv ES Windows,LLC 3550 NW 491h Street Miami,FL 33142 SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials.The documentation submitted has been reviewed and accepted by Miami-Dade County RER - Product Control Section to be used in Miami Dade County and other areas where allowed by the Authority Having Jurisdiction(AHJ). This NOA shall not be valid after the expiration date stated below.The Miami-Dade County Product Control Section(In Miami Dade County)and/or the AHJ(in areas other than Miami Dade County)reserve the right to have this product or material tested forquality assurance purposes.If this product or material fails to perform in the accepted manner,the manufacturer will incur the expense of such testing and the AHJ may immediately revoke,modify,or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is determined by Miami-Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein,and has been designed to comply with the Florida Building Code,including the High Velocity Hurricane Zone. DESCRIPTION: Series"EL400"Aluminum Sliding Glass Door-L.M.I. APPROVAL DOCUMENT:Drawing No.W16-73 RevB,titled"ES-EL400Alum. Sliding Glass Door (L.M.I.)",sheets 1 through 23 of23,dated 11/28/16 and last revised on DEC 30, 2020, prepared by A1- Farooq Corporation, signed and sealed by Jalal Farooq, P.E., bearing the Miami-Dade County Product Control Revision stamp with the Notice of Acceptance number and revision date by the Miami-Dade County Product Control Section. MISSILE IMPACT RATING:Large and Small Missile Impact Resistant Limitations: 1. See Elevations in sheets 1,2,3,4 and anchors requirements. See Header anchor capacity charts in sheet 6 and Glass capacity VS size in sheet 5.Overall Lower Design Pressure(DP)controls for entire the assembly. 2. See sheets 7 thru 13 for various configurations,tracks,pockets,non-pockets and allowable frame area. LABELING:Each unit shall bear a permanent label with the manufacturer's name or logo,B aran qu ill a, Columbia, S.A.,series,andthe following statement: "Miami-Dade County Product Control Approved", unless otherwise noted herein. RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials,use,and/or manufacture of the product or process.Misuse of this NOA as an endorsement of any product,for sales,advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA_ ADVERTISEMENT: The NOA number preceded by the words Miami-Dade County, Florida, and followed by the expiration date maybe displayed in advertising literature. If any portion of the NOA is displayed,then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. This NOA revises NOA# 16-0617.02 consists of this page 1 and evidence pages E-1,E-2 and E-3,as well as approval document mentioned above. The submitted documentation was reviewed by Ishaq 1.Chanda,P.E. NOA No.20-1118.06 MIAMI•DADE CO ' �� L�y h�� Expiration Date: July 20,2022 "'• • UNTY Approval Date: January 07,2020 Page 1 ES Windows, LLC NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 1. Evidence submitted underprevious approval. A. DRAWINGS 1. Manufacturer's die drawings and sections. 2. Drawing No. W16-73, titled "ES-EL400 Alum.Sliding Glass Door (L.M.L)", sheets I through 23 of 23, dated 11/28/16, with revision A dated 07/12/17, prepared by Al- Farooq Corporation, signed and sealed by Javad Ahmad,P.E. B. TESTS 1. Test reports on: 1) Air Infiltration Test, per FBC,TAS 202-94 2)Uniform Static Air Pressure Test, Loading per FBC,TAS 202-94 3)Water Resistance Test,per FBC,TAS 202-94 4)Forced Entry Test, per FBC, and TAS 202-94 6)Large Missile Impact Test per FBC, TAS 201-94 7)Cyclic Wind Pressure Loading per FBC,TAS 203-94 along with marked-up drawings and installation diagram of an aluminum sliding glass door,prepared by Blackwater Testing, Inc., Test Report No.BT-ESW-17-009, dated 06/15/17, signed and sealed by Constantin Bortes, P.E. with Letter of Clarification issued on 07/13/17, signed and sealed by Constantin Bortes, P.E. C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC-5th Edition (2014) and FBC-6th Edition (2017), dated 06/20/17 and revised on 07/13/17, prepared by Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E. 2. Glazing complies with ASTM E1300-09. D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER) E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 16-1117.01 issued to Kuraray America, Inc. for their "Trosifol®Ultraclear, Clear and Color PVB Glass Interlayers", expiring on 07/08/19. 2. Notice of Acceptance No. 14-0916.11 issued to Kuraray America, Inc. for their "Sentry Glass® (Clear and White) Glass Interlayer", expiring on 07/04/18. 3. Notice of Acceptance No. 15-1201.11 issued to Eastman Chemical Co. (MA) for their"Saflex Clear and Color Glass Interlayers" dated 03/17/16, expiring on 05/21/21. 4. Notice of Acceptance No. 14-0423.15 issued to Eastman Chemical Co. (MA) for their"Saflex CP—Saflex and Saflex HP Composite Glass Interlayers with PET Core"dated 06/19/14,expiring on 11/11/18. F. STATEMENTS 1. Statement letter of conformance, complying with FBC-51h Edition(2014) and FBC-61h Edition (2017) dated 07/12/17, issued by Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E. Ishaq I.Chanda, P.E. Product Control Unit Supervisor NOA No.20-1118.06 Expiration Date: July 20,2022 Approval Date: January 07,2020 E- 1 ES Windows, LLC NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED F. STATEMENTS(continue) 2. Statement letter of no financial interest, dated 07/12/17, issued by Al-Farooq Corporation, signed and sealed by Javad Ahmad,P.E. 3. Distributor Agreement, signed by Carlos Garcia and by Evelyn Daes. 4. Laboratory compliance statement for Test Report No. BT-ESW-17-009, issued by Blackwater Testing, Inc.,dated 06/15/17, signed and sealed by Dennis Duffy,CEO. 5. Proposal No. 16-1478 issued by the Product Control Section, dated 11/17/16, signed by Ishaq I.Chanda,P.E. 2. New Evidence submitted A. DRAWINGS 1. Drawing No. W16-73 Rev B, titled "ES-EL400 Alum. Sliding Glass Door (L.M.I.)", sheets 1 through 23 of 23, dated 11/28/16 and last revised on Dec 30, 2020, prepared by Al-Farooq Corporation, signed and sealed by Jalal Farooq, P.E. B. TESTS 1. None. C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC-7th Edition (2020), dated 11/18/20,prepared by Al-Farooq Corporation, signed and sealed by Jalal Farooq, P.E. 2. Glazing complies with ASTM E1300-09 &-16. E. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER) E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 19-0305.02 issued to Kuraray America, Inc. for their "Trosifol® Ultraclear, Clear and Color PVB Glass Interlayers", expiring on 07/08/24. 2. Notice of Acceptance No. 17-0808.02 issued to Kuraray America, Inc. for their "SentryGlas® (Clear and White) Glass Interlayers", expiring on 07/04/23. 3. Notice of Acceptance No. 15-1201.11 issued to Eastman Chemical Co. (MA) for their "Saflex Clear and Color Glass Interlayers", expiring on 05/21/21. 4. Notice of Acceptance No. 18-0301.06 issued to Eastman Chemical Co. (MA) for their "Saflex CP—Saflex and Saflex HP Composite Glass Interlayers with PET Core", expiring on 11/11/23. F. STATEMENTS 1. Statement letter of conformance, complying with FBC-7"' Edition (2020) and No financial interest, dated 11/18/20, issued by Al-Farooq Corporation, signed and sealed by Jalal Farooq, P.E. 2. Test Lab Compliance statement,as part of test report. L 4,1,1 Ishaq 1.Chanda, P.E. Product Control Unit Supervisor NOA No.20-1118.06 Expiration Date: July 20,2022 Approval Date: January 07,2020 E- 2 ES Windows, LLC NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED G. OTHER 1. This NOA revises NOA No. 16-0617.02 and updates to FBC 2020 (Th Edition) expiring 07/20/22. 2. Distribution agreement between Energia Solar, S.A.-ES Windows and ES Windows, LLC,dtd 08/03/15, signed by Ms. Carla Garcia(MGR) and Andres Chamorro (Gen. MGR)respectively (original copy in various ES approved NOA(s) files. Ishaq 1.Chanda, P.E. Product Control Unit Supervisor NOA No.20-1118.06 Expiration Date: July 20,2022 Approval Date: January 07,2020 E- 3