HomeMy WebLinkAboutNOA - CLIPPED MULLION 9-24-20 NOA No. 20-0610.10
Expiration Date: March 28, 2023
Approval Date: September 24, 2020
Page 1
MIAMI-DADE COUNTY
PRODUCT CONTROL SECTION
DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER)
11805 SW 26 Street, Room 208
Miami, FL 33175
BOARD AND CODE ADMINISTRATION DIVISION T (786) 315-2590 F (786) 315-2599
NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/economy
CGI Windows and Doors, Inc.
3780 W 104th Street
Hialeah, FL 33018
SCOPE:
This NOA is being issued under the applicable rules and regulations governing the use of construction
materials. The documentation submitted has been reviewed and accepted by Miami-Dade County RER -
Product Control Section to be used in Miami Dade County and other areas where allowed by the Authority
Having Jurisdiction (AHJ).
This NOA shall not be valid after the expiration date stated below. The Miami-Dade County Product Control
Section (In Miami Dade County) and/or the AHJ (in areas other than Miami Dade County) reserve the right
to have this product or material tested for quality assurance purposes. If this product or material fails to
perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may
immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER
reserves the right to revoke this acceptance, if it is determined by Miami-Dade County Product Control
Section that this product or material fails to meet the requirements of the applicable building code.
This product is approved as described herein, and has been designed to comply with the Florida Building
Code, including the High Velocity Hurricane Zone.
DESCRIPTION: Series Clipped Mullion – L.M.I.
APPROVAL DOCUMENT: Drawing No. MD-MULCLIP, titled “Clipped Mullion”, sheets 1 through 7
of 7, dated 05/22/2020, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E., bearing
the Miami-Dade County Product Control Revision stamp with the Notice of Acceptance number and
expiration date by the Miami-Dade County Product Control Section.
MISSILE IMPACT RATING: Large and Small Missile Impact Resistant
LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state,
model/series, and following statement: "Miami-Dade County Product Control Approved", unless otherwise
noted herein.
RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been
no change in the applicable building code negatively affecting the performance of this product.
TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change
in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement
of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure
to comply with any section of this NOA shall be cause for termination and removal of NOA.
ADVERTISEMENT: The NOA number preceded by the words Miami-Dade County, Florida, and
followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is
displayed, then it shall be done in its entirety.
INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its
distributors and shall be available for inspection at the job site at the request of the Building Official.
This NOA revises NOA# 18-0129.08 and consists of this page 1 and evidence pages E-1 and E-2, as well as
approval document mentioned above.
The submitted documentation was reviewed by Sifang Zhao, P.E.
09/24/2020
Sifang Zhao, P.E.
Product Control Examiner
NOA No. 20-0610.10
Expiration Date: March 28, 2023
Approval Date: September 24, 2020
E - 1
CGI Windows and Doors, Inc.
NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED
1. EVIDENCE SUBMITTED UNDER PREVIOUS NOA’s
A. DRAWINGS
1. Manufacturer's die drawings and sections. (Submitted under NOA No. 95-0929.39)
2. Drawing No. M95-13A, titled Series Clipped, Extruded Aluminum Tube Mullion –
L.M.I.”, sheets 1, 2, 3, 3.1, 4, 4.1 and 5 of 5, dated 11/25/95, with revision H dated
01/16/18, prepared by Al-Farooq Corporation, signed, sealed by Javad Ahmad, P.E.
B. TESTS
1. Test reports on: 1) Air Infiltration Test, per FBC, TAS 201-94
2) Uniform Static Air Pressure Test, Loading per FBC, TAS 202-94
3) Water Resistance Test, per FBC, TAS 202-94
4) Small Missile Impact Test per FBC, TAS 201-94
5) Large Missile Impact Test per FBC, TAS 201-94
along with marked-up drawings and installation diagram of casement windows mulled
using a 1”x 2”x 1/8” aluminum tube mullion, prepared by Hurricane Testing Lab, Inc.,
Test Report No. HTL-0080-0105-08, dated 03/26/08 for Specimens No. 1 and 2,
signed and sealed by Vinu J. Abraham, P.E. (Submitted under NOA No. 08-0331.07)
2. Test reports on: 1) Large Missile Impact Test, Loading per SFBC, PA 201-94
along with marked-up drawings and installation diagram of an aluminum fixed
window, prepared by Hurricane Test Laboratory, Inc. Test Report No.
HTL-0080-0303-96, dated 03/06/96, signed and sealed by Timothy S. Marshall, P.E.
(Submitted under NOA No. 95-0929.39)
3. Test reports on: 1) Uniform Static Air Pressure Test, Loading per SFBC, PA 202-94
along with marked-up drawings and installation diagram of fixed windows mulled
using a 1”x 2”x 1/8” aluminum tube mullion, prepared by Hurricane Engineering &
Testing, Inc., Test Report No. HETI-96-525, dated 02/12/96, signed and sealed by
Hector M. Medina, P.E. (Submitted under NOA No. 95-0929.39)
C. CALCULATIONS
1. Anchor verification calculations and structural analysis, complying with FBC 5th
Edition (2014), dated 04/13/15 and 07/25/15, prepared by Al-Farooq Corporation,
signed and sealed by Javad Ahmad, P.E.
2. Glazing complies with ASTM E1300-09
D. QUALITY ASSURANCE
1. Miami-Dade Department of Regulatory and Economic Resources (RER).
E. MATERIAL CERTIFICATIONS
1. None
Sifang Zhao, P.E.
Product Control Examiner
NOA No. 20-0610.08
Expiration Date: March 28, 2023
Approval Date: September 24, 2020
E - 2
CGI Windows and Doors, Inc.
NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED
F. STATEMENTS
1. Statement letter of conformance, complying with FBC 5th Edition (2014), with FBC
6th Edition (2017), and of no financial interest, dated October 4, 2017, issued by Al-
Farooq Corporation, signed and sealed by Javad Ahmad, P.E.
G. OTHERS
1. NOA No. 15-0420.08, issued to CGI Windows & Doors for their Series “Clipped”
Aluminum Tube Mullion – L.M.I., approved on 08/13/15 and expiring on 03/28/18.
2. NEW EVIDENCE SUBMITTED
A. DRAWINGS
1. Drawing No. MD-MULCLIP, titled “Clipped Mullion”, sheets 1 through 7 of 7, dated
05/22/2020, prepared by manufacturer, signed and sealed by Anthony Lynn Miller,
P.E.
B. TESTS
1. None.
C. CALCULATIONS
1. Anchor verification calculations and structural analysis, complying with FBC-6th
Edition (2017) and FBC-7th (2020) dated 06/05/2020, prepared by manufacturer,
signed and sealed by Anthony Lynn Miller, P.E.
D. QUALITY ASSURANCE
1. Miami-Dade Department of Regulatory and Economic Resources (RER)
E. MATERIAL CERTIFICATIONS
1. None.
F. STATEMENTS
1. Statement letter of conformance, complying with FBC 6 th Edition (2017) and with FBC
7th Edition (2020), and of no financial interest, dated 05/22/2020, signed and sealed by
Anthony Lynn Miller, P.E.
2. Statement letter of successor engineer per 61G15-27.001 Florida Administrative Code.
G. OTHERS
1. NOA No. 18-0129.08, issued to CGI Windows & Doors for their Series “Clipped”
Aluminum Tube Mullion – L.M.I., approved on 03/19/18 and expiring on 03/28/23.
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10
352'8&75(9,6('DVFRPSO\LQJZLWKWKH)ORULGD%XLOGLQJ&RGH
12$²1R
([SLUDWLRQ'DWH
%\
0LDPL²'DGH3URGXFW&RQWURO
03/28/2023
20-0610.10