The URL can be used to link to this page

Home My WebLink AboutNOA - ALUMINUM FIXED WINDOW NOA No. 20-1116.02 Expiration Date: January 16, 2025 Approval Date: February 25, 2021 2/16/21 Page 1 MIAMI-DADE COUNTY PRODUCT CONTROL SECTION 11805 SW 26 Street, Room 208 DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) Miami, Florida 33175-2474 BOARD AND CODE ADMINISTRATION DIVISION T (786) 315-2590 F (786) 315-2599 NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/building E.S. Windows, LLC 3550 NW 49th Street Miami, FL 33142 SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The documentation submitted has been reviewed and accepted by Miami–Dade County RER– Product Control Section to be used in Miami–Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ). This NOA shall not be valid after the expiration date stated below. The Miami–Dade County Product Control Section (In Miami–Dade County) and/ or the AHJ (in areas other than Miami–Dade County) reserve the right to have this product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance if it is determined by Miami–Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein and has been designed to comply with the Florida Building Code, including the High Velocity Hurricane Zone. DESCRIPTION: Series “ES-P252 Thermally Broken” Aluminum Fixed Window – L.M.I. APPROVAL DOCUMENT: Drawing No. 18-05D, titled “ES-P252 Thermal Aluminum Fixed Wdw. (L.M.I)”, sheets 1 through 6 of 6, dated 12/27/17, with revision B dated 11/09/20, prepared by Al-Farooq Corporation, signed and sealed by Jalal Farooq, P.E., bearing the Miami-Dade County Product Control Revision stamp with the Notice of Acceptance number and expiration date by the Miami-Dade County Product Control Section. MISSILE IMPACT RATING: Large and Small Missile Impact Resistant LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, Barranquilla, Colombia, model/series, and following statement: "Miami–Dade County Product Control Approved", unless otherwise noted herein. RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials, use, and/ or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. ADVERTISEMENT: The NOA number preceded by the words Miami–Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. This NOA revises NOA No. 18-0312.02 and consists of this page 1 and evidence pages E-1, E-2 and E-3, as well as approval document mentioned above. The submitted documentation was reviewed by Manuel Perez, P.E. Manuel Perez, P.E. Product Control Examiner NOA No. 20-1116.02 Expiration Date: January 16, 2025 Approval Date: February 25, 2021 E – 1 E.S. Windows, LLC NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 1. EVIDENCE SUBMITTED UNDER PREVIOUS NOA’s A. DRAWINGS 1. Manufacturer's die drawings and sections. (Submitted under NOA No. 18-0312.02) 2. Drawing No. 18-05D, titled “ES-P252 Thermal Aluminum Fixed Wdw. (L.M.I)”, sheets 1 through 6 of 6, dated 12/27/17, with revision A dated 06/01/18, prepared by Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E. (Submitted under NOA No. 18-0312.02) B. TESTS 1. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202-94 2) Uniform Static Air Pressure Test, Loading per FBC TAS 202-94 3) Water Resistance Test, per FBC, TAS 202-94 4) Large Missile Impact Test per FBC, TAS 201-94 5) Cyclic Wind Pressure Loading per FBC, TAS 203-94 along with marked-up drawings and installation diagram of series ES-P252 fixed windows mock-ups 1 thru 6, prepared by Blackwater Testing, Inc., Test Report No. BT-ESW-17-022, dated 12/05/17, signed and sealed by Constantin Bortes, P.E. (Submitted under NOA No. 18-0312.02) 2. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202-94 2) Uniform Static Air Pressure Test, Loading per FBC TAS 202-94 3) Water Resistance Test, per FBC, TAS 202-94 4) Large Missile Impact Test per FBC, TAS 201-94 5) Cyclic Wind Pressure Loading per FBC, TAS 203-94 along with marked-up drawings and installation diagram of series ES-P252 fixed windows mock-ups 7 thru 9, prepared by Blackwater Testing, Inc., Test Report No. BT-ESW-17-022B, dated 02/14/18, signed and sealed by Constantin Bortes, P.E. (Submitted under NOA No. 18-0312.02) C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC 6th Edition (2017), dated 01/05/18, prepared by Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E. (Submitted under NOA No. 18-0312.02) 2. Glazing complies with ASTM E1300-09 D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER). Manuel Perez, P.E. Product Control Examiner NOA No. 20-1116.02 Expiration Date: January 16, 2025 Approval Date: February 25, 2021 E – 2 E.S. Windows, LLC NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 1. EVIDENCE SUBMITTED UNDER PREVIOUS NOA’s (CONTINUED) E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 17-0808.02 issued to Kuraray America, Inc. for their “SentryGlas® (Clear and White) Glass Interlayers” dated 12/28/17, expiring on 07/04/23. 2. 0.315-inch (Length) by 0.26-inch (Height) by 0.0059-inch (Thickness) (8x6.6x0.15mm) Aluminum Low Profile Insulated-Glass spacer Helima AH 800 N (P/N.: USA K 001 000 000 R7) with Aluminum Alloy AW-3000 (Ftu=17 ksi and Fty=12ksi) by Helmut Lingemann GmbH & Co., KG. (Helima). 3. Ensinger, GmbH Part No. Tecatherm 66 GF Insulbar complying with ASTM D638 Tensile Strength of 13,031 psi, ASTM D 1929 Self Ignition 793oF and Flash Ignition – 781oF, ASTM D 2843 Smoke Density of 1.63, ASTM D 635 Rate of Burn 0.752 in./ min., ASTM D 790 Flexural Modulus of 870 ksi, ASTM D 256 Notched Izod of 1.9 ft.- lb./in. F. STATEMENTS 1. Statement letter of conformance, complying with FBC 6th Edition (2017), and of no financial interest, dated January 05, 2018, issued by Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E. (Submitted under NOA No. 18-0312.02) 2. Distributor Agreement between ES Windows–Energia Solar, S.A., Barranquilla, Columbia, S.A. and ES Windows, LLC, Miami, Florida, dated 09/12/13, signed by Ms. Adriana Montoya, Manager and Andres Chamorro, General Manager respectively on behalf of the companies. (Submitted under NOA No. 18-0312.02) G. OTHERS 1. None. Manuel Perez, P.E. Product Control Examiner NOA No. 20-1116.02 Expiration Date: January 16, 2025 Approval Date: February 25, 2021 E - 3 E.S. Windows, LLC NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED 1. NEW EVIDENCE SUBMITTED A. DRAWINGS 1. Drawing No. 18-05D, titled “ES-P252 Thermal Aluminum Fixed Wdw. (L.M.I)”, sheets 1 through 6 of 6, dated 12/27/17, with revision B dated 11/09/20, prepared by Al-Farooq Corporation, signed and sealed by Jalal Farooq, P.E. B. TESTS 1. None. C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC 6th Edition (2017), dated 01/05/18, and updated on 11/16/20 to comply with FBC 7th Edition (2020), prepared by Al-Farooq Corporation, signed and sealed by Jalal Farooq, P.E. 2. Glazing complies with ASTM E1300-09 D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER) E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 18-0725.11 issued to Kuraray America, Inc. for their “Kuraray SentryGlas® XtraTM (SGXTM) Clear Glass Interlayer” dated 05/23/19, expiring on 05/23/24. F. STATEMENTS 1. Statement letter of conformance, complying with FBC 6th Edition (2017), with FBC 7th Edition (2020), and of no financial interest, dated November 16, 2020, issued by Al- Farooq Corporation, signed and sealed by Jalal Farooq, P.E. G. OTHERS 1. Notice of Acceptance No. 18-0312.02, issued to E.S. Windows, LLC, for their Series “ES-P252 Thermally Broken” Aluminum Fixed Window – L.M.I., approved on 01/16/20 and expiring on 01/16/25.