The URL can be used to link to this page

Home My WebLink AboutESTATE BY WINDOOR PW 20-0519.14NOA No. 20-0519.14 Expiration Date: October 26, 2023 Approval Date: October 28, 2020 Page 1 MIAMI-DADE COUNTY PRODUCT CONTROL SECTION DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) 11805 SW 26 Street, Room 208 Miami, FL 33175 BOARD AND CODE ADMINISTRATION DIVISION T (786) 315-2590 F (786) 315-2599 NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/economy WinDoor, Inc. 7500 Amsterdam Drive Orlando, FL 32832 SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The documentation submitted has been reviewed and accepted by Miami-Dade County RER - Product Control Section to be used in Miami-Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ). This NOA shall not be valid after the expiration date stated below. The Miami-Dade County Product Control Section (In Miami-Dade County) and/or the AHJ (in areas other than Miami-Dade County) reserve the right to have this product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is determined by Miami-Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein, and has been designed to comply with the Florida Building Code, including the High Velocity Hurricane Zone. D APPROVAL DOCUMENT: 11, dated 05/12/20, with revision A dated 05/12/20, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E., bearing the Miami-Dade County Product Control Revision stamp with the Notice of Acceptance number and Expiration date by the Miami-Dade County Product Control Section. MISSILE IMPACT RATING: Large and Small Missile Impact Resistant. LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state, model/series, and following statement: "Miami-Dade County Product Control Approved", unless otherwise noted herein. RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. ADVERTISEMENT: The NOA number preceded by the words Miami-Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. This NOA revises NOA#18-1001.17 and consists of this page 1 and evidence pages E-1 and E-2, as well as approval document mentioned above. The submitted documentation was reviewed by Sifang Zhao, P.E. 06/25/2021 Sifang Zhao, P.E. Product Control Examiner NOA No. 18-1001.17 Expiration Date: October 26, 2023 Approval Date: October 28, 2020 E - 1 WinDoor, Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED A. DRAWINGS 1.Manufacturer's die drawings and sections (See NOA #20-0519.06) 2. dated 05/12/20, with revision A dated 05/12/20, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. B. TESTS 1. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202-94 2) Uniform Static Air Pressure Test, Loading per FBC, TAS 202-94 3) Water Resistance Test, per FBC, TAS 202-94 4) Large Missile Impact Test per FBC, TAS 201-94 5) Cyclic Wind Pressure Loading per FBC, TAS 203-94 along with marked-up drawings and installation diagram of all PGT Industries, Inc. CGI Windows and Doors, Inc., representative units listed below and tested to qualify Dowsil 791 and Dowsil 983 silicones, per Proposal #19-1155TP, prepared by Fenestration Testing Laboratory, Inc., Test Reports No.: CGI Windows and Doors Inc. test specimens: FTL-20-2108.1, CGI SH360 Aluminum Single Hung Window (unit 1 in proposal) FTL-20-2108.2, CGI CA238 Alum. Outswing Casement Window (unit 2 in proposal) FTL-20-2108.3, CGI SGD560 Aluminum Sliding Glass Door (unit 3 in proposal) FTL-20-2108.4, CGI PW410 Aluminum Fixed Window (unit 4 in proposal) and FTL-20-2108.5, CGI SH360 Aluminum Single Hung Window (unit 5 in proposal) all dated 08/24/20 and signed and sealed by Idalmis Ortega, P.E C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC 7th Edition (2020), dated 05/12/20, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. 2. Glazing complies with ASTM E1300-04, -09, -12 and -16. D. QUALITY ASSURANCE 1. Miami-Dade Department of Regulatory and Economic Resources (RER). E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No. 18-0725.11 issued to Kuraray America, Inc. for their Kuraray SentryGlas® XtraTM (SGXTM) Clear Glass Interlayer dated 05/23/19, expiring on 05/23/24. Sifang Zhao, P.E. Product Control Examiner NOA No. 18-1001.17 Expiration Date: October 26, 2023 Approval Date: October 28, 2020 E - 2 WinDoor, Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED E. MATERIAL CERTIFICATIONS (continued) 2. Notice of Acceptance No. 19-0305.02 issued to Kuraray America, Inc. for their Trosifol® Ultraclear, Clear and Color PVB Glass Interlayers dated 05/09/19, expiring on 07/08/24. 3. Notice of Acceptance No. 18-0301.06 issued to Eastman Chemical Company (MA) Saflex CP - Saflex and Saflex HP Composite Glass Interlayers with PET dated 05/17/18, expiring on 12/11/23. 4. Notice of Acceptance No. 17-0712.05 issued to Eastman Chemical Company (MA) Saflex Clear and Color Glass Interlayers dated 09/07/17, expiring on 05/21/21. F. STATEMENTS 1. Notification of Successor Engineer per the Florida Administrative Code Section 61G15-27.001, notifying original engineer that the successor engineer is assuming full professional and legal responsibility for all engineering documents pertaining to this NOA, dated 06/12/20, signed and sealed by A. Lynn Miller, P.E. 2. Statement letter of conformance, of complying with FBC 6th Edition (2017), and FBC 7th Edition (2020) dated 05/12/2021, issued by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. 3. Statement letter of no financial interest dated 05/12/2021, issued by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. G. OTHERS 1. Private labeling agreement between WinDoor, Inc. and CGI Windows and Doors, Inc. document in conformance of RER guideline dated 09/12/2018. (Submitted under NOA No. 18-1001.17) 2. Notice of Acceptance No. 18-1001.17, issued to WinDoor, Inc. Aluminum Fixed Window - L.M.I., approved on 12/13/2018 and expiring on 10/26/23. 3. Notice of Acceptance No. 20-0519.06, issued to CGI Windows and Doors, Inc. for Window - L.M.I., approved on 02/15/18 and expiring on 10/26/23. 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14 10/26/2023 20-0519.14