HomeMy WebLinkAboutStep Railing Detail - WikelHOME PRIDE
Home Pride BOCA compliant rails follow all dimensional requirements shown below.
No more than 4" top rail spacing (parallel)
Nin mnra than 4"
PLATFosh
14GI &VT
Mn mnra than 4" frnm
6" sh
r
between bottom bar and stair tread
MIL1N&, As SlAcwN,
WI t L BE tN SrAL%.Ep
p" goTN S►DES 'O�:
FIBEI2GL.ASS' STEPS
T
No more than 4" picket spacin
1
q
36
All side rails are attached via lag bolts (6) and washers (6) connected to threaded T-nuts (6). The T-nuts
are preinstalled by Home Pride on the inside of the step frame work. Pilot holes for connecting the Lag
bolts and T-nuts are pre -drilled and protected with plastic plugs during storage and transport.
All back rails are attached at two locations. First, the back rail is bolted to the side rail using a corner
connecting bracket (1), bolts (2), nuts (2) and a protective corner cover (1). Second, the legs of the back
rail are attached via lag screws (4) drilled directly into the plywood facing and/or frame of the step.
Side and back rail hardware packets are shown below:
Side Rail Hardware
Back Rail Hardware
pa,ev.of"ti
m