Loading...
HomeMy WebLinkAboutRoofing Application Standards-� ROOFING APPLICATION STANDARD (RAS) No.128 k S STANDARD PROCEDURE FOR DETERMINING APPLICABLE WIND DESIGN • PRESSURES FOR LOW SLOPE ROOF 1. Scope 1.1 This roofing application standard has been developed to provide a responsive method of complying with the require- ments of Chapters 15 & 16 (High -Veloc- ity Hurricane Zones) of the Florida Building Code, Building. Compliance with the requirements and procedures herein specified, where the pressures (Pass) have been determined based on Ta- ble 1 or 2, of this standard, as applicable, do not require additional signed and sealed engineering design calculations. All other calculations must be prepared, signed and sealed by a professional engi- neer or registered architect. 2. Definitions 2.1 For definitions of terms used in this appli- cation standard, refer to ASTM D 1079 and the Florida Building Code, Building. 3. Applicability 3.1 This application standard applies to: a. exposure C and D category build- ings; and b. building heights of Jess than or equal to 40 feet; and C. roof incline (pitch) is not greater than V, in.:12 in. d. risk category II buildings. 3.2 Using Table 1 or 2 below, as applicable, determine the minimum design pressure for each respective roof area, which corre- sponds to the applicable roof height range. 3.3 Referencing the selected Roof Assembly Product Approval, check that the listed maximum allowable design pressure for the particular approved system meets or exceeds those listed in Table 1 or Table 2 above, as applicable. :TABLE 1 — RIS�K CCATEGORYkII�EXPOSWRE CA EGORY` _ EIL&rPdl MINIMUM DESIGN IND UPL�FTPRESSURES IN PSF-FOR ].)], PERIMETER fPasd(2)] AND CORNER [Pesd(3)] AREAS O ROOFq F„OR EX S E C"!BUILDINGS Roof mean P.d(1) (Field) P.d(2) (Perimeter) Pnd(3) (Corners) height (below) •20", x.� - _ -428' _ - - - 7VT- —� '�-71.7.. — -108:0� 25 -44.8 -75.1 -113.0 30 -46.4 -77.8 -117.2 35 -48.1 -80.6 -121.3 40 -49.4 -82.9 -124.7 t Calculated in accordance with ASCE 7. 2 P.d = 0.6Putt FLORIDA BUILDING CODE — TEST PROTOCOLS FOR HVHZ, 5th EDITION (2014) (RAS)128.1