HomeMy WebLinkAboutNOAMlidil�l�[7W171�
e A) MIAMI-DADE COUNTY
PRODUCT CONTROL SECTION
DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) 11805 SW 26 Street, Room 208
BOARD AND CODE ADMINISTRATION DIVISION Miami, Florida 33175-2474
T (786) 315-2590 F (786) 315-2599
NOTICE OF ACCEPTANCE (NOA) W+w.ndamidade.eov/economy
Continental Materials, Inc.
1614 Old York Road
Abington, PA 19001
SCOPE:
This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The
documentation submitted has been reviewed and accepted by Miami -Dade County RER - Product Control Section to be
used in Miami Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ).
This NOA shall not be valid after the expiration date stated below. The Miami -Dade County Product Control Section
(In Miami Dade County) and/or the AHJ (in areas other than Miami Dade County) reserve the right to have this
product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted
manner, the manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, or
suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance,
if it is determined by Miami -Dade County Product Control Section that this product or material fails to meet the
requirements of the applicable building code.
This product is approved as described herein, and has been designed to comply with the Florida Building Code
including the High Velocity Hurricane Zone of the Florida Building Code.
DESCRIPTION: Continental Materials All Weather #30; Continental Materials All Weather #90
LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state and following
statement: "Miami -Dade County Product Control Approved", unless otherwise noted herein.
RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change
in the applicable building code negatively affecting the performance of this product.
TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the
materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product,
for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section
of this NOA shall be cause for termination and removal of NOA.
ADVERTISEMENT: The NOA number preceded by the words Miami -Dade County, Florida, and followed
by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then
it shall be done in its entirety.
INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and
shall be available for inspection at the job site at the request of the Building Official.
This NOA consists of pages 1 through 2.
The submitted documentation was reviewed by Alex Tigera.
N1�A5'Y0 Expira
Approval Date: 05/02/13
Page 1 of 2
ROOFING COMPONENT APPROVAL
Category Roofing
Sub -Category: Underlayment
Material: Asphalt
PRODUCTS DESCRIPTION:
Product Dimensions
Continental Materials All 36" x 72' rolls
Weather #30
Test Product
Specification Description
ASTM D 226 Type H Asphalt Saturated Felt Underlayment
Continental Materials All 36" x 36' rolls ASTM D 6380 Class M Asphalt Saturated Felt Underlayment
Weather #90 Type H
MANUFACTURING LOCATION:
1. Mexicali, Mexico
EVIDENCE SUBMITTED:
Test Agency Test Identifier Test Name/Report Date
PRI Construction Materials CMI-031-02-01 ASTM D 226 05/09/12
Technologies
CMI-032-02-01
INSTALLATION
ASTM D 6380
05/09/12
1. Continental Materials All Weather #30 and All Weather #90 shall be installed in strict compliance with
applicable Building Codes.
LIMITATIONS:
1. Fire classification is not part of this acceptance.
2. This acceptance is for prepared roofing applications. Minimum deck requirements shall be in compliance with
applicable building code. Continental Materials All Weather #30 and #90 underlayment shall be installed in strict
compliance with applicable Building Code.
3. Continental Materials All Weather #30 and #90 underlayments shall not be left exposed as a temporary roof for
longer than 30 days of application.
4. All products listed herein shall have a quality assurance audit in accordance with the Florida Building Code and
Rule 9N-3 of the Florida Administrative Code.
5. All packaging shall bear the imprint or identifiable marking of the manufacturer's name or logo and a
yellow line in the center of the roll to identify the ASTM Standard designation or the Miami -Dade County
Product Control Seal as shown below.
MIAMI•DADE COUNTY
END OF THIS ACCEPTANCE
NOA No.: 12-0612.30
Expiration Date: 05/02/18
Approval Date: 05/02/13
Page 2 of 2