Loading...
HomeMy WebLinkAboutHAZARDS BY LOCATION3/18/2019 CiTC Search Ir Coordinates: Elevation: Timestamp: Hazard Type: ASCE 7-16 by Location ATC Hazards by Location 27.32507468179306,-80.44396371282807 31ft 2019-03-18T20:24:15.067Z Wind MRI 10-Year 88 mph MRI25-Year 106 mph MRI50-Year 118 mph MRI 100-Year 129 mph Risk Category 1 145 mph Risk Category II A 156 mph You are in a wind-borne debris region. Risk Category III ® 167 mph If the structure under consideration is a healthcare facility and you are also within 1 mile of the coastal mean high water line, you are in a w+nd-borne debris region. If other occupancy, use the Risk Category II basic wind speed contours to determine if )iou are in a wind-borne debris region. Go` i gle ASCE 7-10 MRI 10-Year 88 mph MRI25-Year 106 mph MRI50-Year 118 mph MRI 100-Year 129 mph Risk Category 1 145 mph Risk Category 11 ® 156 mph You are in a wind-borne debris region, Risk Category III -IV ® 167 mph If the structure under consideration is a healthcare facility and you are also within 1 mile of the coastal mean high water line, you are in a wind-borne debris region. If other occupancy, use the Risk Category 11 basic wind speed contours to determine if you are in a wind-borne debris region. Risk Category IV ® 176 mph ittps://hazards.atco uncil.org4/wind?tat=27.32507468179306&ing=-80.44396371282807&address= 311ft 1 Map i Report a map err^r ASCE 7-05 ASCE 7-05 Wind Speed A 134 mph You are in a wind-borne debris region. 1/2 3/18/2019 ATC Hazards by Location You are in a wind-borne debris region. The results indicated here DO NOT reflect any state or local amendments to the values or any delineation lines made during the building code adoption process. Users should confirm any output obtained from this tool with the local Authority Having Jurisdiction before proceeding with design. Disclaimer Hazard loads are interpolated from data provided in ASCE 7 and rounded up to the nearest whole integer. Per ASCE 7, islands and coastal areas outside the last contour should use the last wind speed contour of the coastal area — in some cases, this website will extrapolate past the last wind speed contour and therefore, provide a wind speed that is slightly higher. NOTE: For queries near wind-borne debris region boundaries, the resulting determination is sensitive to rounding which may affect whether or not it is considered to be within a wind-borne debre, region. Mountainous terrain, gorges, ocean promontories, and special wind regions shall be examined for unusual wind conditions. While the information presented on this website is believed to be correct, ATC and its sponsors and contributors assume no responsibility or liability for its accuracy. The material presented in the report should not be used or relied upon for any specific application without competent examination and verification of its accuracy, suitability and applicability by engineers or other licensed professionals. ATC does not intend that the use of this information replace the sound judgment of such competent professionals, having experience and knowledge in the field of practice, nor to substitute for the standard of care required of such professionals in interpreting and applying the results of the report provided by this website. Users of the information from this website assume all liability arising from such use. Use of the output of this website does not imply approval by the governing building code bodies responsible for building code approval and interpretation for the building site described by latitude/longitude location in the report. https://hazards.atcouncii.orgl#lwind?lat=27.32507468179306&ing=-80.44396371282807&address= 212