HomeMy WebLinkAboutNOA�erelvep FILE COPY
SUN i� In REl91ElIEs'E®
MIAMI-DADE Depa�ntet\C M
CODE C®&MSS COUNTY
s iM\tttin9,e 9c' SECTION
DEPARTNIENT OF REGULATOR1t��'ND ECONONIIC RESOURC&SdR I uc Ir �j ���Room 08 BOARD AND CODE ADNDNISTRATION DIVISION e� 0 �i. 7$6y
CGI Windows and Doors, Inc. %3WM1l1r.0
10100 NW 25th Street BYpa,,
Miami, FL 33172 SQ, Lude VUu*
SCOPE:
This NOA is being issued under the applicable rules and regulations governing the use of construction
materials. The documentation submitted has been reviewed and accepted by Miami -Dade County RER -
Product Control Section to be used in Miami -Dade County and other areas where allowed by the Authority
Having Jurisdiction (AHD.
This NOA shall not be valid after the expiration date stated below. The Miami -Dade County Product Control
Section (In Miami Dade -County) and/or the AHJ (in areas other than Miami -Dade County) reserve the right
to have this product or material tested for quality assurance purposes. If this product or material falls to
perform in the accepted manner, the manufacturer will incur the expense of such testing and the ANJ may
immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER
reserves the right to revoke this acceptance, if it is determined by Miami -Dade County Product Control
Section that this product or material fails to meet the requirements of the applicable building code.
This product is approved as described herein, and has been designed to comply with the Florida Building
Cade, including the High Velocity Hurricane Zone.
DESCRIPTION: Series "Sentinel 130" Aluminum Fixed Window - LALL
APPROVAL DOCUMENT: Drawing No. W10-02, titled `Series Sentinel 130 Alum Fixed Window
(L.M.I.) (S.M.I.)", sheets 1, 1.1, 2, 3, 4, 5 and 6 of 6, dated 01/30/10, with revision G dated 08/29/17,
prepared by Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E., bearing the Miami -Dade
County Product Control Revision stamp with the Notice of Acceptance number and expiration date by the
Miami —Dade County Product Control Section.
MISSILE IMPACT RATING: Large and Small Missile Impact Resistant
LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state,
model/series, and following statement: "Miami -Dade County Product Control Approved", unless otherwise
noted herein.
RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been
no change in the applicable building code negatively affecting the performance of this product
TERIVIINATION of this NOA will occur after the expiration date or if there has been a revision or change
in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement
of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure
to comply with any section of this NOA shall be cause for termination and removal of NOA.
ADVERTISEMENT: The NOA number preceded by the words Miami -Dade County, Florida, and
followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is
displayed, then it shall be done in its entirety.
INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its
distributors and shall be available for inspection at the job site at the request of the Building Official.
This NOA revises NOA No.15-0413.03 and consists of this page I and evidence pages E-1, E-2 and E-3, as
well as approval document mentioned above.
The submitted documentation was reviewed by Manuel Perez, P.E.
NOA No.17-0918.07
Expiration Date: September 22, 2020
1 Il�SI !7 Approval Date: November 22, 2017
Page 1
CGI Windows and Doors, Tue.
NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED
1. EVIDENCE SUBMITTED UNDER PREVIOUS NOA's
A. DRAWINGS
1. Manufacturer's die drawings and sections.
(Submitted under NOA No.10- 0510. 13)
2. Drawing No. W10-02, titled Series Sentinel 130 Alum Fixed Window (L.M.I.)
(S.M.I.), sheets 1,1.1, 2, 3, 4, 5 and 6 of 6, dated 01/30/10, with revision F, dated
04/10/15, prepared by Al-Farooq Corporation, signed and sealed by Javad Ahmad,
P.E.
B. TESTS
1. Test reports on. 1) Uniform Static Air Pressure Test, Loading per FBC TAS 202-94
2) Large Missile Impact Test per FBC, TAS 201-94
3) Cyclic Wind Pressure Loading per FBC, TAS 203-94
along with marked -up drawings and installation diagram of a series 7500 PVC fixed
window, to qualify DuPont `Butacite' PVB interlayer, Duraseal® and Super Spacer®
insulating glass spacer, prepared by Certified Test Laboratories, Test Report No.
CT'LA 3056 WA, dated 03/03/15, signed and sealed by Ramesh C. Patel, P.E.
2. Test reports on: 1) Uniform Static Air Pressure Test, Loading per FBC TAS 202-94
2) Large Missile Impact Test per FBC, TAS 201-94
3) Cyclic Wind Pressure Loading per FBC, TAS 203-94
along with marked -up drawings and installation diagram of a series 7400 PVC project
out window, to qualify DuPont `Butacite" PVB interlayer, Duraseal® and Super
Spacer® insulating glass spacer, prepared by Certified Test Laboratories, Test Report
No. CTLA-3056 WB, dated 03/03/15, signed and sealed by Ramesh C. Patel, P.E.
3. Test reports on: 1) Uniform Static Air Pressure Test, Loading per FBC TAS 202-94
2) Large Missile Impact Test per FBC, TAS 201-94
3) Cyclic Wind Pressure Loading per FBC, TAS 203-94
along with marked -up drawings and installation diagram of a series 238 aluminum
fixed window, to qualify DuPont `Butacite" PVB interlayer, Duraseal® and Super
Spacer® insulating glass spacer, prepared by Certified Test Laboratories, Test Report
No. CTLA-3056 WC, dated 04/16/15, signed and sealed by Ramesh C. Patel, P.E.
4. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202-94
2) Uniform Static Air Pressure Test, Loading per FBC TAS 202-94
3) Water Resistance Test, per FBC, TAS 202-94
4) Large Missile Impact Test per FBC, TAS 201-94
5) Cyclic Wind Pressure Loading per FBC, TAS 203-94
along with marked -up drawings and installation diagram of a Sentinel 130 aluminum
fixed window, prepared by Hurricane Test Laboratory, LLC, Test Report No.
HTL-0080-0103-10, dated 03/30/10, signed and sealed by Vinu J. Aboikml P.E.
(Submitted under NOA No. 10-0510.13) �7W Toii9Za
Product Contro Exat#iner
NOA No. 7 18.07
Expiration Date: September 22, 2020
Approval Date: November 22, 2017
E-1
CGI Windows and Doors. Inc.
NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED
C. CALCULATIONS
1. Anchor verification calculations and structural analysis, complying with FBC-5"
Edition (2014), dated July 18, 2014, prepared by Al-Farooq Corporation, signed and
scaled by Javad Abroad, P.E.
(Submitted uuder NOA No. 14-073L05)
2. Glazing complies with ASTM E1300-09.
D. QUALITY ASSURANCE
1. Miami -Dade Department of Regulatory and Economic Resources (RER)
E. MATERIAL CERTIFICATIONS
1. Notice of Acceptance No. 11-0624.02 issued to E.I. DuPont DeNemours & Co., Inc.
for their "DuPont SentryGlas® Interlayee dated 08/25/11, expiring on 01/14/17.
2. Notice of Acceptance No. 13-0129.27 issued to E.I. DuPont DeNemouts & Co., Inc.
for their "DuPont Butacite® PVB Interlayer" dated 04/11/13, expiring on 12/11/16.
3. Notice of Acceptance No.14-0423.17 issued to Eastman Chemical Company (MA)
for their "Saflex Clear and Color Glass Interlayers" dated 0619/14, expiring on
05/21/16.
4. Notice of Acceptance No. 14-0423.15 issued to Eastman Chemical Company (MA)
for their "Saflex CP - Saflex and Saflex HP Composite Glass Interlayers with PET
Core" dated 06/19/14, expiring on 12/11/18.
F. STATEMENTS
1. Statement letter of conformance, complying with FBC-P Edition (2014), and of no
financial interest, dated July 18, 2014, issued by Al-Farooq Corporation, signed and
sealed by Javad Abroad, P.E.
(Submitted under NOA No. 14-0 731.05)
2. Laboratory compliance letter for Test Report No. HTL-0080-0103-10, issued by
Hurricane Test Laboratory, LLC, dated March 30, 2010, signed and sealed by Vinu J.
Abraham, P.E.
(Submitted under NOA No.10-0510.13)
3. Testing Proposal issued by the Product Control Section, dated 12/16/14, signed by
Jaime Gascon, P.E., Supervisor, Product Control Section
G. OTHERS
1. Notice of Acceptance No. 14-0731.05, issued to CGI Windows & Doors, for their
Series "Sentinel 130" Aluminum Fixed Window — LAU. approved on 10/16/14 and
expiring on 09/22/15.
Manuel ere
Product Control Ex ain r
NOA No.17-0 .07
Expiration Date: September 22, 2020
Approval Date: November 22, 2017
E-2
CGI Windows and Doors, Inc.
NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED
2. NEW EVIDENCE SUBMITTED
A. DRAWINGS
1. Drawing No. W10-02, titled Series Sentinel 130 Alum Fixed Window (L.M.I.)
(S.M.I.), sheets 1,1.1, 2, 3, 4, 5 and 6 of 6, dated 01/30/10, with revision G, dated
08/29/17. prepared by Al-Farooq Corporation, signed and sealed by Javad Ahmad,
P.E.
B. TESTS
1. None.
C. CALCULATIONS
1. Anchor verification calculations and structural analysis, complying with F13C 6"
Edition (2017), dated July 15, 2017, prepared by Al-Farooq Corporation, signed and
sealed by Javad Ahmad, P.E.
2. Glazing complies with ASTM E1300-09.
D. QUALITY ASSURANCE
1. Miami -Dade Department of Regulatory and Economic Resources (RER)
E. MATERIAL CERTIFICATIONS
1. Notice of Acceptance No. 14-0916.11 issued to Kuraray America, Inc. for their
"SentryGlas® (Clear and White) Glass Interlaye°is" dated 06/25/15, expiring on
07/04/18.
2. Notice of Acceptance No. 16-1117.01 issued to Kuraray America, Inc. for their
"TrosifolO Ultraclear, Clear and Color PVB Interlayers" dated 01119/17, expiring
on 07/08/19.
3. Notice of Acceptance No. 17-0712.03 issued to Eastman Chemical Company (MA)
for their "Saflex CP - Saflex and Saflex HP Composite Glass Interlayers with
PET Core" dated 09/07/17, expiring on 12/11/18.
4. Notice of Acceptance No. 17-0712.05 issued to Eastman Chemical Company (MA)
for their "Saflex Clear and Color Glass Interlayers" dated 09/07/17, expiring on
05/21/21.
F. STATEMENTS
1. Statement letter of conformance, of complying with FBC 5t° Edition (2014), with
FBC 61 Edition (2017) and of no financial interest, dated August 15, 2017, issued by
Al-Farooq Corporation, signed and sealed by Javad Ahmad, P.E.
G. OTHERS
1. Notice of Acceptance No. 15-0413.03, issued to CGI Windows & Doors, for their
Series "Sentinel 130" Aluminum Fixed Window - .M.I. approved o 6/25/15 and
expiring on 09/22/20.
E-3
Manuel P , P.E.
Product Control miner
NOA No. 17-0918.07
Expiration Date: September 22, 2020
Approval Date: November 22, 2017