HomeMy WebLinkAboutCHECKLISTFlorida Building Code
DESIGN PROCEDURE Exposure t'
Wind Zone �ph
Attach all appropriate Engineering Designs and Specifications
from Lawrence Bennett, Robert Monsour, or other approved
engineering manual to the top of this sheet.
SCANNEu
CHECKLIST BY
SQ. LllCil? C�tlrrlh
Items needed:
❑ 2 copies of site plans to scale, with all dimensions of Existing and New
structures, and showing front, sides, and rear set backs.
❑ 2 copies of clean, precise, and scaled plans, on a nummum of 8.5 x 11 and
maximum of 11 x 17 sheets.
❑ Top View, showing beam sizes and span lengths, column locations, line
indicating overhang, host attachment, and. all dimensions.
❑ Front View, column location and distance between, beam sizes & length,
girt locations, and all dimensions.
❑ Side View, column location and distance between, beam sizes & length,
girt locations, and all dimensions.
❑ 2 sets of highlighted engineers sheets from appropriate manual for all
attachments.
❑ 2 copies of the Design Procedure Checklist from the AAF Manual
OR the design component checklist from 2001 Bennett Engineering Manual
❑ All window and door pressures and attachments noted on plans & checklist.
❑ 2 copies of Dealer signed attachment letter with lot and block number, and
street address of installation. Or 4a' wall design details.
NOTE: If application, plans, or checklist are incomplete they will not be accepted at
the counter or if received by mail they will be returned to the applicant.
I, the Contractor, take full responsibility for complying with the submitted calculations of the design
pressures for the openings of the structure being permitted. I certify that the components being used,
fastener type, and fastening pattern meets the proper design pressures for the. structure located in the
designated wind zones set by the county, along with applicable tables 1606.2A;1606.213,1606.2C, and
1606.2D or chapter 20 of the Florida Buildil node.