HomeMy WebLinkAboutTAMKO ROOFING PRODUCTSJun 242 04 01:44p TRMKO
8005418849
be a minimum of 22 gauge.
RATE
INSULATION
INSULATION
TAMKO
(PSF)
ATTACHMENT
SPECIFICATION
FIRST LAYER
SECOND LAYER
105
Iso, min. 1.3" thick,
Any combination,
1st layer: mech.
Any insulated
w/ glass facer
any thickness:
fastened --see list
TAMKO specification
Iso, EPS, cellular glass,
2nd layer: hot
partite, woodfiber
mopped
90
Iso, min. 1.3' thick,
Mechanically
Any insulated
w/ glass facer
fastened
TAMKO specification
with base sheet' spot
mopped to iso w/12"
diameter spots
spaced 24" o.c.
90
OPTIONAL: Iso, min 1.3'
Perlite, min. 1/2" thick
Both layers mech.
Any Insulated TAMKO
thick w/ glass facer
fastened w/ base
specification installed
sheer. See fastener
in hot asphalt or heat
pattern below
welded
Use #4 fastener.
75
OPTIONAL: Iso, min 1.3"
Perlite, min. 1/2" thick
Both layers mech.
101C 201C
thick w/ glass facer
fastened w/ base
107C 207C
sheer. See fastener
w/TAM-PRO CPA
pattern below
SBS Adhesive
Use 04 fastener.
BASE SHEET FASTENER PATTERN
Fasten the sheets along the lap at intervals of no more than 9 in. Stagger -nail on 18 in. centers along two lines located
12 in. from each edge of the base sheet. Fasteners must be Olympic No. 12-11 screws with 3" diameter galvanized
steel plates 0.018" min. thickness.
'ACCEPTABLE BASE SHEETS: Glass -Base, Base-N-Ply, Versa -Base, Vapor -Chan or Versa -Smooth
INSULATION FASTENER PATTERN
A total of 16 fasteners per each 4 ft. by 8 ft. sheet used (1 fastener/2 sq. ft.), positioned in three rows. Rows located 6
Inches from the 8 foot sides and along the centerline. Six fasteners used in outer rows, four used down the center.
Any of the following fastener systems may be used:
1) FABCO "System ES" consisting of a No. 13 screw and a 3 In. plastic plate.
2) DEKFAST No. 12 or No. 14 stand-off screw with a 2-7/8" coated hex -plate, 0.017" min. thickness.
3) BUILDEX Hextra screws with Gearlok locking 3" diameter plastic plates or nominal 3" x 3" galvanized steel plates
iderjtified as Hextra/Accutrac plates.
4) OLY MPIC No.12-11 screws with 3-1/4" diameter plastic plates or 3" diameter galvanized steel plates 0.018" min. thickness.
TAMKO Roofing Products, Inc., P.C. Box 1404, Joplin, MO 64902.1.800.641-4691 • w .tannko.ccm
Jn 93a7F 12W
23