The URL can be used to link to this page

Home My WebLink AboutNOASCANNED BY MIAMI•DADE St. Lucie County MIAMI-DADE COUNTY ® PRODUCT CONTROL SECTION DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) 11805 SW 26 Street, Room 208 BOARD AND CODE ADMINISTRATION DIVISION T (786) 315-2590 F (786) 315.2599 NOTICE OF ACCEPTANCE (NOA) www.miamidadu¢ov/economy PGT Industries, Inc. 1070 Technology Drive North Venice, FL 34275 .SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of construction materials. The documentation submitted has been reviewed and accepted by Miami -Dade County RER - Product Control Section to be used in Miami Dade County and other areas where allowed by the Authority Having Jurisdiction (AHJ). This NOA shall not be valid after the expiration date stated below. The Miami -Dade County Product Control Section (In Miami -Dade County) and/or the AHJ (in areas other than Miami -Dade County) reserve the right to have this product or material tested for quality assurance purposes. If this product or material fails to perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER reserves the right to revoke this acceptance, if it is determined by Miami —Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approv as a in, and has been designed to comply with the Florida Building Code, including the igh Velocity Hu ican Zone: DESCRIPTION: eries "SGD-770" Al inum Sliding Glass Door w / 90° & 135° corners — L.M.I. APPROVAL DOC NT: Dr ' g No. PGT0130, titled "Series 770 Alum. SGD - LM Impact', sheets 1 through 22 of 22, dated 10/10/14, with revision C dated 04/05/17, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E., bearing the Miami -Dade County Product Control Revision stamp with the Notice of Acceptance number an ' a ion date by the Miami- a e o— roduct Control Section. MISSILE IMPACT RA G: Large and Small Missile Impact Resistant LABELING: Each unit sh ear a permanent label with the manufactu name or logo, city, state, model/series, and following statement: a uc ontrol Approved", unless otherwise noted herein. RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. ADVERTISEMENT: The NOA number preceded by the words Miami -Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall be done in its entirety. —INSPECTION:-. A copy of -this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection afthe job site aEthe requesfofthe-Building Official.=- _ - This NOA revises NOA# 16-0629.06 and consists of this page 1 and evidence pages E-1 and E-2, as well as approval document mentioned above. The submitted documentation was reviewed by Jorge M. Plasencia, P.E. aloe NOA No. 17-0420.12 rtwno-oaoe couNrr Expiration Date: February 17, 2020 Approval Date: September 28, 2017 Page 1 PGT Industries, Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED A. DRAWINGS 1. Manufacturer's die drawings and sections. (Submitted underNOANo. 14-0123.10) 2. Drawing No. PGT0130, titled "Series 770 Alum. SGD — LM Impact", sheets 1 through 22 of 22, dated 10/10/14, with revision C dated 04/05/17, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. B. TESTS 1. Reference Test report on 1) Uniform Static Air Pressure Test, per FBC, TAS 202-94 2) Large Missile Impact Test per FBC, TAS 201-94 3) Cyclic Wind Pressure Loading per FBC, TAS 203-94 Along with marked -up drawings and installation diagram of Aluminum Sliding Glass Doors (w/ PS, Super, Cardinal & Duraseal Spacers), prepared by Fenestration Testing Laboratory, Inc., Test Reports No(s) FTL-8717, FTL-8970 and FTL-8968, dated 02/15/16, 06/17/16 and 06/20/16, all signed & sealed by Idalmis Ortega, P.E. (Submitted under NOA No.16-0629.06) 2. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202-94 2) Uniform Static Air Pressure Test, Loading per FBC, TAS 202-94 3) Water Resistance Test, per FBC, TAS 202-94 4) Large Missile Impact Test per FBC, TAS 201-94 5) Cyclic Wind Pressure Loading per FBC, TAS 203-94 6) Forced Entry Test, per FBC 2411.3.2.1, and TAS 202-94 along with marked -up drawings and installation diagram of an ahmrinum sliding glass door, prepared by Fenestration Testing Laboratory, Inc., Test Report No. FTL-7554, dated 11/01/13, signed and sealed by Marlin D. Brinson, P.E. (Submitted under NOA No. 14-0123. 10) 3. Test reports on: 1) Air Infiltration Test, per TAS 202-94 2) Uniform Static Air Pressure Test, Loading per TAS 202-94 3) Water Resistance Test, per TAS 202-94. 4) Forced Entry Test per FBC 2411.3.2.1 and TAS202-94. 5) Large Missile Impact Test, per TAS 201-94 6) Cyclic Wind Pressure Loading, per TAS 203-94 along with marked -up drawings and installation diagram of aluminum Sliding Glass Doors, prepared by Fenestration Testing Laboratory, Inc., Test Report No FTL-5980, FTL-5993, FT1,6036, FTL-6001, FTL-6014, FTL-6015, FTL-6017, FTL-6023, FTL-6024, FTL-6025, FTL-6028, FTL-6031, FTL-6033 and FTL-6036 dated --- _ = 08/10/09, all"signed and sealed by -Julio -Gonzales RE.- — _ Note: The test reports No. FTL 5980, FTL 6001 and FTL 6015 have been revised and reissued on 12/29/09, signed and sealed by Julio Gonzales (Submitted under NOA No. 09-0826.10) Jorge M. Plasencia, P.E. P� duct Control Unit Supervisor NOA No.17-0420.12 Expiration Date: February 17, 2020 Approval Date: September 28, 2017 E-1 PGT Industries, Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED B. TESTS (CONTINUED) S. Additional Reference Fixed Window Test Report No. FTL-7897 (Cardinal spacer), per TAS 201, 202 & 203-94, issued by Fenestration Testing Laboratory, Inc. (Submitted under NOA No. I5-0430.08) C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC-5t" Edition (2014) and FBC-61 Edition (2017), dated 04/18/17 and revised on 08/10/17, prepared by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. 2. Glazing complies with ASTM E1300-09 D. QUALITY ASSURANCE 1. Miami -Dade Department of Regulatory and Economic Resources (RER). E. MATERIAL CERTIFICATIONS 1. Notice of Acceptance No.16-1117.01 issued to Kuraray America, Inc. for their "Trosifol® Ultraclear, Clear and Color PVB Glass Interlayers" dated 01/19/17, expiring on 07/08/19. 2. Notice of Acceptance No.14-0916.11 issued to Kuraray America, Inc. for their "SentryGlas® (Clear and White) Glass Interlayers" dated 06/25/15, expiring on 07/04/18. F. STATEMENTS 1. Statement letter of conformance with FBC-5" Edition (2014) and FBC-6" Edition (2017), dated 08/10/17, issued by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. 2. Statement letter of no financial interest, dated 04/18117, issued by manufacturer, signed and sealed by Anthony Lynn Miller, P.E. 3. Test proposal No.16-0152 dated 03/09/16 approved by RER. 4. Lab compliance as part of the above referenced Test Report No(s) FTL-8717, FTL- 8970 and FTL-8968. G. OTHERS 1. Notice of Acceptance No.16-0629.06, issued to PGT Industries, Inc. for their Series "SGD-770" Aluminum Sliding Glass Doors w/90° &135° comers - L.M.I. approved on 08/04/16 and expiring on 02/17/20. < Jorge M. Plasencia, P.E. P� duct Control Unit Supervisor NOA No. 17-0420.12 Expiration Date: February 17, 2020 Approval Date: September 28, 2017 E-2