HomeMy WebLinkAboutSUB-CONTRACTOR AGREEMENTPERMIT# ISSUE DATE
the
For the project located at
PLANNING & DEVELOPMENT SERVICES
Building & Code Compliance Division
BUILDING PERMIT
SUB -CONTRACTOR AGREEMENT
SCANNED
St C(,cBCounty
have agreed to be
Sub -contractor for-T
(Primary Contractor)
or Property Tax ID
I � —Cx)�>3'
It is understood that, if there is any change of status regarding our participation with the above mentioned
project, the Building and Code Regulation Division of St. Lucie County will be advised pursuant to the
filing of a Change of Subcontractor notice.
_/'�TCONTRACTOR SIGNATURE (Quaaaer) SUB•CO\TRACTOR SIC —NATURE (Qoalifirr)k fnC til-
PRINT N.U11E PRINT NAME
COUNTY CERTIFICATION N MBER
State of Florda. County of
The foregoing internment was signed ^�/ before me this " t day of
who G personally Immvn Z.r has prodneed a
COUNTY CERTIFICATION NUMBER
Sate of Florida. County of
The foregoing Instrument rnu 3ignM before on, thlt _ day or
by
who is personally mown _or has produced a
as identification.
as identification.
STAMP
Signature of Notary Public
Signature I rNotary Public
Print Now of Notary Public
MEtj$,$AIESKI
Print Name of Notary Public
A��b'
MYCOMMISSIONUGG243423
_ i•• •:
D�IRES: December 13 2022
tti. o•
�i�',
'�?ncaM1oe:
pip{C Undcnwaora
fiq�aQillNNtAaIY a
Revisca 11/162016
STANIP
970 f1-CLICCI ]
0 "'
1903-0261 PERMIT REQUIREMENTS
SECTION 2606 LIGHT -TRANSMITTING PLASTICS
Planning &.. Developmental Services Department
Building &Code Regulations Division
2606.3 Identification. Each unit or package of light -transmitting plastic shall be identified with a mark or
decal satisfactory to the building official, which includes identification as to the material classification.
2606.4 Specifications. Light -transmitting plastics, including thermoplastic, thermosetting or reinforced
thermosetting plastic material, shall have a self -ignition temperature of 6507 (343°C) or greater where
tested in accordance with ASTM D1929; a smoke -developed index not greater than 450 where tested in
the manner intended for use in accordance with ASTM E84 or LIL 723, or a maximum average smoke
density rating not greater than 75 where tested in the thickness intended for use in accordance with
ASTM D2843 and shall conform to one of the following combustibility classifications:
Class CC3: Plastic materials that have a burning extent of 1 inch (25 mm) or less where tested at a
nominal thickness of 0.060 inch (1.5 mm), or in the thickness intended for use, in accordance with ASTM
D635.
Class CC2: Plastic materials that have a burning rate of 21/2 inches per minute (1.06 mm/s) or less
where tested at a nominal thickness of 0.060 inch (1.5 mm), or in the thickness intended for use, in
accordance with ASTM D635.
Revised 2126119