Loading...
HomeMy WebLinkAboutNotice of Acceptance M IAM I•DADE RITAIH--DADE COUNTY,FLORIDA p PRODUCT CONTROL SECTION DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES.(RER) 11805 SN 26 Street,Room 208 BOARD AND CODE ADDIINISTRATION DIVISION T(786)315-2590 F(786)315-2599 NOTICE OF ACCEPTANCE (NOA) lvmv.miamidade.eov/economy PGT Industries,Inc. 1070 Technology Drive, North Venice,Fl.34275 SCOPE: This NOA is being issued under the applicable rules and regulations governing the use of constriction materials. The documentation submitted has been reviewed and accepted by Miami—Dade County RER— Product Control Section to be used in Miami—Dade County and other areas where allowed by the Authority Having Jurisdiction(AHJ). This NOA shall not be valid after the expiration date stated below. The Miami—Dade County Product Control Section(In Miarni Dade County)and/or the AHJ(in areas other than Miami—Dade County)reserve the right to have this product or material tested for quality assurance purposes. If this.product or material fails to perform in the accepted mamner,the manufacturer will incur the expense of such testing and.the AHJ may immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RVR reserves the right to revoke this acceptance, if it is determined by Miami—Dade County Product Control Section that this product or material fails to meet the requirements of the applicable building code. This product is approved as described herein, and has been designed to comply with the Florida Building Code,including the High Velocity Hurricane Zone. DESCRIPTION:Seri t ern ng . ass oou v e n VC-0 APPROVAL DOCU : Drawing No.PGT0004, titled "Series 770 H.P. Aluminum SGD—L.M.I.", sheets 01 through 10 of 10, dated 08/05/07, prepared by manufacturer, revision "E" dated 12/31/14 and latest update 03/05/15,signed and sealed by Lynn A.Miller,P.E.,bearing the Miami Dade County Product Control Section Renewal stamp with the Notice of Acceptance number and expiration date by the Miami— Dade County Product Control Section. MISSILE IMPACT RATING: e'>is,ra tt LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state, series, and following statement: "Miami—Dade County Product Control Approved", unless otherwise noted herein. REVISION of this NOA shall be considered after a renewal application has been filed and there has been no change in the applicable building code negatively affecting the performance of this product. TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change ' in the materials, use,and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any product,for sales, advertising or any other purposes shall automatically terminate this NOA.Failure to comply with any section of this NOA shall be cause for termination and removal of NOA. ADVERTISEMENT: The NOA number preceded by the words Miami Dade County, Florida, and followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed,then it shall be done in its entirety. INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site at the request of the Building Official. This NOA renews NOA No.13-1009.07 and consists of this page 1 and evidence pages E-1,E-2 and E-3, as well as approval document mentioned above. The submitted documentation was reviewed by Jaime D.Gascon,P.E. NOA No.15-0106 MIAMI•DADECOUNTY Approval Date: March 12,2015 �j1t41 Page 1 PGT Industries,Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED A. DRAWINGS 1. Manufacturer's die drawings and sections. 2. Drawing No. PGT0004, titled "Series 770 H.P. Aluminum SGD — L.M.I.", sheets 01 through 10 of 10, dated 08/05/07, prepared by manufacturer, revision "E" dated 12/31/14 and latest update 03/05/15,signed and sealed by Lynn A.Miller,P. E. B. TESTS 1. Test reports on: 1)Air Infiltration Test,per FBC,TAS 202-94 2) Uniform Static Air Pressure Test,Loading per FBC,TAS 202-94 3) Water Resistance Test,per FBC,TAS 202-94 4) Large Missile Impact Test per FBC,TAS 201-94 5) Cyclic Wind Pressure Loading per FBC,TAS 203-94 6) Forced Entry Test,per FBC 2411.3.2.1,and TAS 202-94 along with marked—up drawings and installation diagram of Aluminum Sliding Glass Door (XOX), prepared by Fenestration Testing Laboratory, Inc., Test Report No. FTL-7825,dated 06/10/2014, signed and sealed by Idalmis Ortega,P. E. 2. Test reports on: 1)Air Infiltration Test,per FBC,TAS 202-94 2) Unifonn Static Air Pressure Test,Loading per FBC,TAS-202-94 3) Water Resistance Test,per FBC,TAS 202-94 4) Large Missile Impact Test per FBC,TAS 201-94 5) Cyclic Wind Pressure Loading per FBC,TAS 203-94 6)Forced Entry Test,per FBC 2411.3.2.1, and TAS 202-94 along with marked—up drawings and installation diagram of Aluminum Sliding Glass Doors (Samples A-1, A 2, B-1, B-2 and C-1), prepared by Fenestration Testing Laboratory, Inc.;Test Report No. FTL-7468, dated 09/13/2013, signed and sealed by Martin D.Brinson,P.E. (Submitted ander previous NOA No. 13-1009.07) 3. Test reports on: 1)Air Infiltration Test,per FBC,TAS 202-94 2) Uniform Static Air Pressure Test,Loading per FBC,TAS 202-94 3) Water Resistance Test,per FBC,TAS 202-94 4)Large Missile Impact Test per FBC,TAS 201-94 5) Cyclic Wind Pressure Loading per FBC,TAS 203-94 6) Forced Entry Test,per FBC 2411.3.2.1, and TAS 202-94 along with marked—up drawings and installation diagram of Aluminum Sliding Glass Doors (Samples A-1, A 2, B-1, B-2 and C-1), prepared by Fenestration Testing Laboratory, Inc., Test Report No. FTL-5998R, dated 12/29/09, revised, signed and sealed by Julio Gonzales,P. E. (Subrrritted ander previous NOA No. 09-0826.12) l r. Jaime D.Gascon,P.E. Product Control Section Supervisor NOA No.15-0106.08 Expiration Date: March 24,2020 Approval Date: March 12,2015 E-1 PGT Industries,Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED B. TESTS (CONTINUED) 4. Test reports on: 1)Air Infiltration Test,per FBC,TAS 202-94 2) Uniform Static Air Pressure Test,Loading per FBC,TAS 202-94 3) Water Resistance Test,per FBC,TAS 202-94 4) Large Missile Impact Test per FBC, TAS 201-94 5) Cyclic Wind Pressure Loading per FBC, TAS 203-94 6)Forced Entry Test,per FBC 2411.3.2.1,and TAS 202-94 along with marked-up drawings and installation diagram of Aluminium Sliding Glass Doors (Samples A-1, A 2, B-1, B-2 and C-1), prepared by Fenestration Testing Laboratory, Inc., Test Reports No.'s FTL-5998, FTL -6005 and FTL-6012, elated 08/10/09, all signed and sealed by Julio Gonzales,P.E. (Submitted under previous NOA No. 09-0826.12) 5. Additional reference supporting Test Reports No.'s ATI72138.01-401-18 and FTL-5254. C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC 5"' Addition (2014), prepared by manrrfachirer, dated 03/05/15, signed and sealed by Lynn A.Miller,P.E. 2. Glazing complies with ASTM E1300-04/09 D. QUALITY ASSURANCE 1. Miami Dade Department of Regulatory and Economic Resources (RER). E. MATERIAL CERTIMCATIONS 1. Notice of Acceptance No. 14-0916.10 issued to Kuraray America, Inc. for their "Kuraray PVB Glass Interlayer"dated 03112/15, expiring on 12/11/16. F. STATEMENTS 1. Statement letter of conformance to and complying with FBC 5"'Edition(2014),issued by manufacturer, elated 12/31/14, signed and sealed by Lynn A.Miller,P. $. 2. Laboratory compliance letter for Test Report No. FTL-7825, issued by Fenestration Testing Laboratory,Inc., dated 06/10/14,signed and sealed by Idahmis Ortega,P.E. 3. Department of State Certification of PGT INDUSTRIES, INC. as a for profit corporation, active and organized under the laws of. the State of Florida, dated 01/27/15 and filed by the Secretary of State. 4. Statement letter of commitment, issued by manufacturer, dated 02/20/14, signed and sealed by Lynn A. Miller,P.E. �- (Srrbrnitted rarder previous NOA No. 13-1009.07) -- - •Jaime D.Gascon-'-p.E. Product Control Section Supervisor NOA No. 15-0106.08 Expiration Date: March 24,2020 Approval Date: March 12,2015 E-2 PGT Industries,Inc. NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED F. STATEMENTS (CONTINUED) 5. Statement letter of conformance to and complying with FBC 2010, issued by manufacturer,dated 10/04/13, signed and sealed by Lynn A.Miller,P. E. (Submitted carder previous NOA No. 13-1009.07) 6. Statement letter of no financial interest, issued by manufacturer, dated 10/04/13, signed and sealed by Lynn A. Miller,P.E. (Srrburitted under previous NOA No. 13-1009.07) 7. Laboratory addendum letter for Test Report No. FTL-7468, issued by Fenestration Testing Laboratory,Inc., dated 01/13/14,signed by Manny Sanchez, CEO. (Suburitted rider previous NDA No. 13-1009.07) 8. Laboratory compliance letter for Test Report No. FTL-7468, issued by Fenestration Testing Laboratory, Inc., dated 09/13/13, signed and sealed by Martin D.Brinson,P.E. (Submitted under previous NOA No. 13-1009.07) 9. Proposal, dated 06/04/13, issued by the Product Control, signed by Jaime D. Gascon, P. E. (Submitted under previous NOA No. 13-1009.07) 10. Notification of Successor Engineer for manufacturer's NOA document per Section 61G15-27.001 of the Florida Administrative'Code, notifying original engineer that the successor engineer is assuming Rill professional and legal responsibility for all engineering documents pertaining to this NOA, dated 10/07/11, signed and sealed by Lynn A.Miller,P. E. (Submitted carder previous NOA No. 11-1018.16) 11. Laboratory compliance letter for Test Reports No.'s FTL--5998, FTL-6005 and FTL-6012,all issued by Fenestration Testing Laboratory, Inc.,dated 08/10/09, signed and sealed by Julio Gonzales,P.E. (Submitted tattler previous NOA No. 09-0826.12) 12. Proposals No.'s 09-0177-A, dated 05/05/09, B, dated 05/27/09 and -C, dated 05/27/09, all issued by the Product Control, signed by Ishaq Chanda,P.E. (Submitted under previous NOA No. 09-0826.12) G. OTHERS 1. Notice of Acceptance No. 13-1009.07, issued to PGT Industries, Inc. for their Series "770-13P Aluminum Sliding Glass Doors w / Reinforcements - L.M.T.", approved on 02/28/14 and expiring on 03/24/15. Jaime D.Gascon,P.E. Product Control Section Supervisor - NOA No.15 0106.08 Expiration Date: March 24,2020 Approval Date: March 12,2015 E-3