HomeMy WebLinkAboutMisc Letters C0 Gary j Gifford,Inc. EC 13001574
Electric Contractor
350 SW Linden St.
Stuart,FL 34997
This Contract is entered into by and between Gary J.Gifford,Inc.and Comcast Cable
Communications.
The specific terms of this Contract are as follows:
Address: FPL meter AA15030-3106 N Highway A1A#CATV
PCN: 1425-606-0000-0008
Installation of one(1)Comcast power supply cabinet with(2)ground rods
SEVEN HUNDRED TWENTY TWO DOLLARS($722.00)
Gary 1.Gifford,Inc.
By.(// October 21,2016
Maya Gifford
Title:--PxesideA
CoKA
rnmunications
8y: Date:_ October 21,2016
Tit l�VOW
772-286-0954 office 772-219-0146 fax 772-215-4011 mobile
giffelec@comcast.net
c\ t'
RECEI'.'rD OCT 2 8 2010
From: Brege,Paul Paul.Brege@dot.state.fl.us B
Subject: RE:Updated Information-Damaged Comcast Cabinet at 3201 N Al A#CATV-Maintenance?
Date: October 25,2016 at 11:00 AM
To: giffelec@comcast.net
Hello Maya,
It looks like we can do this as maintenance to the cabinet no permit required
Thanks,
Paul Brege
Maintenance Manager/Permits
Office (772) 429-4923
Cell (772) 216-4263
E- Mail paul.brege@dot.state.fl.us
.Just make sure that slap is at ground level all areas are sodded and cleaned up to match existing
conditions. Please contact John Kinkaid with Broad Spectrum Asset Maintenance Contractor 481-Irs
prior to doing any work within the FDOT Right of Way. (772) 360-7119.
From:giffelec@comcast.net [mailto:giffelec@comcast.net)
Sent:Tuesday, October 25, 201610:37 AM
To: Brege, Paul
Subject: Updated Information - Damaged Comcast Cabinet at 3201 N A1A#CATV- Maintenance?
Importance: High
Paul,
Paul,
We are going to install the new Comcast cabinet with meter attached so the front the cabinet is in
line with the back of FPL pole and remove the old cabinet, below grade concrete slab and meter
stanchion. The new cabinet will not go in front or behind the FPL pole. There is 30 ft between
road edge and FPL pole so we will not impact flow of traffic during installation.
Dimensions of new cabinet are:
polymer slab - 48 in. wide x 28 in. deep x 3 in. high
cabinet- 26 in. wide x 17 in. deep x 36 in. tall
I need a St Lucie County electrical permit but was hoping you would not require a DOT permit
primarily because replacement is urgent. There is no cable or fiber work being done - only
setting cabinet and running a 3 ft service feeder from cabinet to FPL pole.
Of course, if we need your permit, I will have the documents prepared and have Wade Hagerty
submit.
Thank you,